1 April 2018 in Theoretical and Applied Fracture Mechanics
1 February 2010 in Proceedings of the Institution of Civil Engineers - Geotechnical Engineering
The mainline railway track between Dublin and Belfast was constructed during the 1850s, with substantial lengths of railway embankment constructed over soft, peaty soils. In recent years Northern Ireland Railways (NIR) has noticed that the sections of the railway track constructed on these peaty soils have been deteriorating at an increasing rate. Train speeds have been reduced in response to concerns that cyclic track displacements appear to be increasing over time in response to train loading. Track maintenance has also increased significantly. The research described in this paper was undertaken to quantify the response to cyclic train loading of two portions of this track founded on peaty soils. Track displacements were recorded using a sensor system specifically created for this project. The sensor consisted of a photosensitive array, mounted on the sleepers, and a laser, which was targeted onto the photosensitive array from a location outside the area of influence of train loading. Track deflections from 5 to 20 mm were measured under train speeds from near zero to over 120 km/h. The temporal variation in track displacement was used to calibrate an analytical (Winkler) model. This analysis suggests that the deformation of the embankment under train loading was not due to dynamic excitation but rather to static deformation of the poor-quality fill and soft foundation materials. As a consequence, the analytical model highlighted that train speed has limited effect on the magnitude of the deflection of the embankment within NIR operating speeds, but has the potential to significantly reduce the power lost to the damping within the embankment and subgrade.
1 December 2016 in Journal of Transportation Engineering
This paper presents the methodology developed for the use of continuous vertical track deflection measurements from a moving loaded rail car to map the subgrade condition along a railway line. This analysis of deflection data was developed following the collection of more than 12,000 km of measurements. It was evident from the collected data that unprocessed deflection measurements are heavily effected by the track surface condition such as joints and geometry irregularities so as to obscure the deflections because of poor subgrade support. A filtering method was employed to minimize the influence of the surface condition which occur at short wavelengths and show the variations in track deflections because of changes in subgrade conditions which occur at longer wavelengths. The resulting processed data are compared with the geology over two study railway subdivisions to demonstrate that the processed vertical track deflection measurements are representative of the subgrade conditions. The filterin...
17 May 2020 in The Canadian Journal of Chemical Engineering
14 December 2019 in Safety in Extreme Environments
15 September 2020 in Safety in Extreme Environments