The paper focuses on determining the frost resistance of concrete using selected destructive and non-destructive test methods. The experiment was performed with four specially made concretes, which differed only in the origin of sand and coarse aggregate. The primary outcome of the experiment are the differences in frost resistance as measured by different methods. In addition, it briefly describes the influence that the choice of aggregate has on the frost resistance of concrete.
The paper deals with the experimental investigation aimed at the continual monitoring of the process of setting and early hardening in cement pastes and mortars using the measurement equipment Vikasonic. The measurement principle consists in measuring the time of ultrasonic pulses transit through a test specimen placed between two ultrasonic transducers. This innovative method of measurement could in the future suitably complement or, in some cases, completely substitute the measurement of setting in cement composites using the Vicat apparatus. The pilot measurement results performed on the cement pastes and mortars are presented in the paper.
The paper deals with the influence of the Poisson’s ratio on the calculated modulus of elasticity of a cementitious composite in the early stage of its ageing. The dynamic modulus of elasticity was determined in the first 24 hours of ageing of the material using the Vikasonic ultrasonic device. Within the experiment, two types of cementitious composites were mixed - cement paste and cement mortar, both having the same water/cement ratio. It is presumed that the value of the dynamic modulus of elasticity calculated on the basis of ultrasonic measurement is closely related to the value of the Poisson’s ratio, which is not constant during ageing of the cementitious composite but varies depending on the degree of hydration of the material. The output of the paper is a comparison of the development of the dynamic modulus of elasticity calculated using different values of the Poisson’s ratio.
This paper deals with the influence of the coarse aggregate grain size on the frost resistance of concrete. For the purpose of the experiment, three types of concrete were produced, varying only in the maximum grain size of the used natural aggregate. The evaluation of the frost resistance of concrete is based on non-destructive (NDT) dynamic and static testing methods. The results of the experiment indicate influences of the aggregate used in the production of the concrete on the results of its frost resistance.
There is a large number of factors that have a strong influence on the elastic modulus of concrete. These are technological influences as well as issues connected with the testing methods for its determination, one of which is the choice of the upper loading stress of cyclic loading during testing the static modulus of elasticity of concrete in compression. The upper loading stress should be equal to 1/3 of the specimen’s compressive strength, however, its choice is often made incorrectly. This paper describes an experiment focused on discovering the impact that deviating from the 1/3 upper loading stress has on the measured value of the static modulus of elasticity.