Stefan G.E. Lampaert

Stefan G.E. Lampaert

Auto-generated profile, based on publicly available information

Stefan G.E. Lampaert

Department of Precision and Microsystem Engineering Technical University Delft Mekelweg 2 2628 CD Delft The Netherlands

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 December 2019 in Current Applied Physics
Verified
Journal Article
Open access
SLS.G.E. Lampaert
S.G.E. Lampaert
RORon Van Ostayen
Ron Van Ostayen

15 September 2019 in Journal of Intelligent Material Systems and Structures
Verified
Journal Article
Closed access
PDF file
SLStefan Ge Lampaert
Stefan Ge Lampaert
RORon Van Ostayen
Ron Van Ostayen
Using a smart fluid, for example, magnetorheological or electrorheological, in a hydrostatic bearing gives the possibility to actively change the bearing properties during operation. This work presents an analytical model to predict the load and stiffness of a planar hydrostatic bearing lubricated with a Bingham plastic fluid. The model is validated with the use of a numerical model that uses the Bingham–Papanastasiou regularization to achieve convergence. The model gives insight into the size of the operational range of the bearing and the load characteristic.

16 October 2019 in Smart Materials and Structures
Verified
Journal Article
Open access
PDF file
ABA S T Boots
A S T Boots
JSJ W Spronck
J W Spronck
RORon Van Ostayen
Ron Van Ostayen
SLS G E Lampaert
S G E Lampaert
Ferrofluid pocket bearings are interesting for fast and precise positioning systems thank to the absence of stick-slip, the low viscous friction and their cost-effective nature. However, the characteristics of the bearing change due to over(de)compression since air escapes out of the enclosed pocket. This article presents an experimentally validated model that includes the air mass inside the pocket in the calculation of the equilibrium position of the ferrofluid bearing. Moreover, a simple and efficient way to obtain the operational range of the bearing is presented and a sensitivity analysis was performed. The sensitivity analysis showed that ferrofluid pocket bearings are always self-aligning and that the tilt stiffness increases when the fly height decreases or the tilt angle increases.

13 November 2019 in Journal of Micromechanics and Microengineering
Verified
Journal Article
Open access
PDF file
SAS M Allebrandi
S M Allebrandi
RORon Van Ostayen
Ron Van Ostayen
SLS G E Lampaert
S G E Lampaert
Magnetic fluids have been around since the 1940s. They come in different forms: magnetorheological fluids (MR fluids) and ferrofluids. MR fluids characterise themselves by having a large change in viscosity under the influence of a magnetic field. Ferrofluids have a significantly smaller change in viscosity, however ferrofluids are colloidal suspensions. After their discovery many applications followed, such as the MR clutch, magnetic damper and bearing applications, in which the fluids are subjected to ultra high shear rates. Little information is available on what happens to the rheological properties under these conditions. In general, the characteristics determined at lower shear rates are extrapolated and used to design new devices. Magnetic fluids have potential in the high tech and high precision applications and their properties need to be known in particular at shear rates around 106 s−1. Commercially available magnetorheometers are not able to measure these fluids at ultra high shear rates and are limited to 105 s−1. Therefore a new magnetorheometer is required to measure ultra high shear rates. In this paper the physical limitations of current measuring principles are analysed and a concept is designed for ultra high shear rate rheometry in combination with a magnetic field. A prototype is fabricated and the techniques used are described. The prototype is tested and compared to a state of the art commercial rheometer. The test results of the prototype rheometer for magnetic fluids show its capability to measure fluids to a range of 104 s−1– s−1 and the capability to measure the magnetorheological effect of magnetic fluids.

1 June 2021 in Results in Engineering
Verified
Journal Article
Open access
STStefan W.M. van Den Toorn
Stefan W.M. van Den Toorn
JSJo W. Spronck
Jo W. Spronck
RORon Van Ostayen
Ron Van Ostayen
SLStefan G.E. Lampaert
Stefan G.E. Lampaert