1 January 2024 in Physics of Fluids
The spatiotemporal correlation of transonic buffet, driven by strong shock waves and boundary-layer separation, plays a critical role in causing structural vibrations in launch vehicles. To investigate this correlation, a wind tunnel experiment was conducted to measure the time-frequency characteristics of wall fluctuation pressures. The phase array approach was employed to obtain the spatial correlation of buffeting load. The results indicate that the low-frequency hydrodynamic modes dominate the separation flow and shock oscillation, while the attached flow is predominantly influenced by broadband acoustic modes. The space-time correlation analysis reveals that the peak buffeting load, for typical flows, results from the convergence of energy beneath the turbulent boundary layer. Furthermore, a similarity law for the spatial correlation of buffeting load was derived and validated by the measurement data. Based on the measured buffeting load data, an improved W–F (Wavenumber–Frequency spectrum) model with scaling spatiotemporal correlation was developed. This model serves as a theoretical foundation for predicting buffeting loads under flight conditions.
1 August 2024 in Physics of Fluids
Wall pressure fluctuations caused by turbulent boundary layers have a significant impact on aircraft structural vibration and cabin noise. This study aims to investigate the mechanism of turbulence-induced pressure fluctuations by focusing on the randomness of wall pressure fluctuations, analyzed in both the time–frequency and spatial-wavenumber domains using measured data obtained from a phase array in a wind tunnel. Three roughness elements were designed and installed upstream of the plate to manipulate the turbulent boundary layer at a specific Mach number. The results of the investigation demonstrate that the disturbance strength induced by the roughness element influences the randomness of wall pressure fluctuations, in addition to the parameters utilized for data analysis. Generally, stronger turbulence fluctuations tend to decrease the randomness of pressure fluctuations. Moreover, wall pressure fluctuations also exhibit certain statistical principles that cannot be precisely calculated using mathematical expressions, highlighting their inherent randomness. Further investigation into randomness in the spatial-wavenumber domain revealed the hydrodynamic modes of turbulence fluctuations with varying convection velocity analyzed through wavenumber maps computed using the beamforming algorithm. These modes with variable convective speed significantly contribute to the generation of randomness in wall pressure fluctuations. Both the time–frequency domain and the spatial-wavenumber domain affect the randomness characteristics of wall pressure fluctuations. However, such effects are not easily discernible through a rudimentary analysis of the space–time correlation of turbulence fluctuations.
1 July 2026 in Physics of Fluids
Solid fuels possess great potential for hypersonic flight due to their high energy density and resistance to high-temperature dissociation. However, traditional idealized chemical reaction assumptions fail to accurately describe the complex multiphase detonation and phase transition mechanisms in reactive flows. To address this, a multiphase chemical equilibrium framework is established to systematically investigate the thermodynamic evolution of boron or aluminum fuels within a continuous rotating detonation ramjet engine (CRDRE) physical testbed. Results indicate that the irreversible complete reaction assumption fails completely across Mach 3–7, as it neglects the dissociation effects at high temperatures and pressures. On the other hand, because the gaseous chemical equilibrium assumption fails to capture the condensation phase transitions when products cross their saturated vapor pressures, the assumption is partially invalid for boron at high equivalence ratios, while it exhibits a global failure for aluminum. Consequently, a condition of Mach 7 and 26 km altitude, presenting the most severe dissociation, is selected as the test condition. Using the irreversible complete reaction assumption for boron leads to an overestimation. Conversely, for aluminum, this assumption does not always overestimate engine performance, which is the result of a balance among the combustor heat release, and the heat release/phase transition losses within the nozzle. Furthermore, results indicate that aluminum yields a higher specific thrust compared to boron, whereas boron exhibits a superior specific impulse. This study enables the rapid calculation of solid-particle fueled detonation parameters and solid-particle fueled CRDRE performance, providing reference for multiphase detonation and phase transitions of solid fuels.