21 May 2022 in Marine Structures
21 March 2024 in The International Journal of Advanced Manufacturing Technology
Ensuring first-time-right on-site repair of critical structures is a key challenge for additive manufacturing (AM)–based repair solutions. Fast thermal simulations are thus needed to plan efficient and error-free AM processes. This paper addresses a fast thermal simulation method for a novel subsea wire arc additive manufacturing (SWAAM) repair procedure. Current commercial finite element (FE) codes for typical welding and AM are computationally expensive and slow. The presented 2D finite difference approach can be used to simulate SWAAM on a damaged plate with around 70 times acceleration compared to real welding times, without the use of parallelization. Although not being able to accurately represent the temperature in close vicinity of the welding torch, the approach shows excellent correspondence with FE simulations and experiments in regions of the plate where the temperature has assumed a distribution that is largely two-dimensional. Compared with FE simulations, the approach is experimentally verified to be accurate to 10 °C within 7 s after the welding torch has passed a point on the plate. Thus, the approach can provide a measure of the global temperature field in a thin-walled structure during repair. The thermal simulation is preceded by a welding path planner, which generates appropriate paths based on slicing of a 3D surface scan of the damage that is to be repaired. Damages to equipment or non-ideal welding conditions are prevented by automatically pausing the welding if the calculated temperature in the path ahead of the welding torch exceeds a predefined interpass temperature limit.
19 July 2024 in The International Journal of Advanced Manufacturing Technology
To ensure sufficient repair of a metal structure damaged from, e.g., corrosion or wear by wire arc additive manufacturing (WAAM), appropriate toolpath planning and prediction of material deposition for the welding process are required. In the current work, a planner employing combined contour and raster pattern paths based on a sliced surface scan of the damage was developed. To extend existing empirical models for material deposition during welding to the two-dimensional paths used in WAAM, a paraboloid deposition function was used. Realistic deposition rates for uneven substrates were ensured by continuously adjusting the vertex height of the paraboloid in closely timed deposition events along the path. The deposition prediction can be used to assess if additional layers of repair welding are needed to fill a damage. For a repair with a build height of around 13 mm, the damage was sufficiently filled after following the generated toolpath plan, and a minimal amount of voids were observed. Errors in the material deposition prediction were within $$\pm 1$$ mm in most of the repair. Errors in the predicted deposition were higher in the start/stop regions of weld beads, presumably because the ignition procedure in the welding machine was not accounted for.
11 September 2022 in Fatigue & Fracture of Engineering Materials & Structures
Corroded surfaces of offshore mooring chains typically show a very irregular shape with different pit geometries. Fatigue tests were performed in three‐point bending on specimens with hemispherical notches, representing an idealized geometry of a corrosion pit. Digital image correlation was used to detect crack initiation lives and locations. The aim of the study was to quantify mean stress relaxation (MSR) and its influence on fatigue initiation life. MSR data were obtained from strain‐controlled fatigue tests on R4‐grade offshore mooring chain steel. Interestingly, MSR was observed even at a stress amplitude below the cyclic yield stress. For initiation lives below 100,000 cycles, significant improvement in predictions was obtained if cyclic softening and MSR were accounted for. Using only the monotonic stress‐strain curve led to less accurate predictions. For longer lives, scatter in the base material data and residual stresses from machining of the notch made predictions less accurate.