1 July 2017 in Metallic foams
Closed cell aluminium foam samples and panels with phase change material (PCM) infiltrated in vacuum were investigated. The utilization of PCMs in larger volumes is strongly limited because of its low thermal conductivity in liquid state. However, porous structure of aluminium foam allows to absorb or to dissipate very homogenously latent heat at almost constant temperature if PCMs with phase change at the temperature range between 4°C and 28 °C are used inside of foam. Therefore the degree of filling of closed cell aluminium foams with PCM material was investigated. It was shown that it is possible to fill sufficient amount of pores with PCM. Further, aluminium foam panels with PCM were tested for heating/cooling applications in buildings. It was confirmed, that such foam panels provide an excellent alternative for large built-in ceiling radiators for efficient heating or cooling of rooms using low potential energy resources. These features of foam panels allow significantly reduce energy consumption of heating/air conditioning systems of future zero energy buildings.
1 October 2021 in Journal of Physics: Conference Series
The internal pore wall structure formation and density play an important role in improving the mechanical and thermal properties of the closed-cell aluminium foams. The present research work aims to investigate the internal structure formation of the aluminium foam prepared by powder metallurgy and the uniformity of the distribution of the pores when the minimum amount of TiH2 is added. The foamable precursor of two different aluminium alloys (Al-1050 and A5083) is produced with a TiH2 gaseous agent of 0.05 wt.%. The parameters analysed include the density, pore wall formations, pore, and metal density distribution inside the structure with the help of X-ray tomography. Furthermore, the image-processing technique has been adopted to produce the 3D surrogate model of the foam for visual inspection and analysis. The obtained results show the importance of the amount of TiH2 addition and of the foaming furnace temperature in deciding the internal porous structure formation. Further, the pore morphology of lower porosity foams (in the range of 30-40 % porosity) of the two alloys produced at 690 °C furnace temperature is investigated with the help of developed surrogate models. The presence of micropores and uniformity of the distribution of pores found brings the idea of choosing the optimized structure of foam for thermal energy storage systems associated with PCM.
1 March 2021 in Advanced Materials Letters
Phase Change Materials Reinforced with Aluminium Foam for Latent Heat Storage
11 December 2025 in Romanian Journal of Technical Sciences - Applied Mechanics
Comprehending the interplay between foam morphology, surface skin, geometry, and compressive behavior is fundamental to the design of advanced functional applications, including energy absorption (EA) systems, seismic mitigation devices, and Phase Change Materialheat storage units. The influence of sample shape (cylinder-CYL, triangular prism-TRP and square prism-SQP) on microstructural and compression behavior was investigated for ductile (AlMg1Si0.6 + 1% wt. ZrH2) and brittle (AlSi12Mg0.6 + 0.4% wt. TiH2) aluminum alloy foams (AAFs). The different compositions and foaming agents led to unique cellular structures. The AAFstructures exhibited heterogeneity, with variations between top and bottom parts of samples, but only small differences in pore numbers were observed. Total number of pores varied according to the cross-sectional shape, with CYLs having significantly more pores compared to TRPsand SQPs. Ductile AAFhad small round pores with thick pore walls, while brittle AAFs exhibited regions with dense and thin pore structures due to coalescence and collapse during foaming. Precursor composition significantly impacted AAF structure, surface skin thickness, and compression.Compression strength, plateau stress, and EA were shape-dependent: SQPs performed best for brittle AAFs, while CYLsamples showed higher ductile compression response and better EAin brittle AAFs. Densification strain was again observed independent on the sample shape, type of alloy, type and amount of foaming agent.