Recent improvements to the CdTe solar cell device structure have focused on replacing the CdS window layer with a more transparent material to reduce parasitic absorption and increase Jsc, as well as incorporating selenium into the absorber layer to achieve a graded band gap. However, altering the CdTe device structure is nontrivial due to the interdependent nature of device processing steps. The choice of the window layer influences the grain structure of the CdTe layer, which in turn can affect the chloride treatment, which itself may contribute to intermixing between the window and absorber layers. This work studies three different device architectures in parallel, allowing for an in-depth comparison of processing conditions for CdTe solar cells grown on CdS, SnO2, and CdSe. Direct replacement of the CdS window layer with a wider band gap SnO2 layer is hindered by poor growth of the absorber, producing highly strained CdTe films and a weak junction. This is alleviated by inserting a CdSe layer between the SnO2 and CdTe, which improves the growth of CdTe and results in a graded CdSexTe1-x absorber layer. For each substrate, the CdTe deposition rate and postgrowth chloride treatment are systematically varied, highlighting the distinct processing requirements of each device structure.
Ultrathin ZnO interlayer boosts TiO 2 –based Sb 2 S 3 solar cells to record efficiencies 7.5% AM 1.5G and 18% indoor. Reduced nonradiative losses, passivated front interface, and larger Sb 2 S 3 grains enable stable power for IoT applications.
Sb2Se3 is an emerging semiconductor which has shown promise for low‐cost photovoltaic applications. After successive record‐efficiencies using a range of device structures, spiro‐OMeTAD has emerged as the default hole transport material (HTM), however, the function of HTM layers remains poorly understood. Here, thin‐film Sb2Se3 solar cells are fabricated with which three organic HTM layers ‐ namely P3HT, PCDTBT, and spiro‐OMeTAD are investigated. By comparing these against one another, and to a reference device, their role in the device stack are clarified. These organic HTM layers are found to serve a dual purpose, increasing both the average and peak efficiency by simultaneously blocking pinholes and improving the band alignment at the back contact, with marginal differences in performance between the different HTMs. This produced a champion device of 7.44% using P3HT, resulting from an improvement in all performance parameters. A more complex processing route, run‐to‐run variability, and lower overall device performance compared to the other organics challenge the assumption that spiro‐OMeTAD is the optimal HTM for Sb2Se3 devices. A Schottky barrier at the Au‐Sb2Se3 contact despite the deep work function of gold implies Fermi level pinning due to a defective interface, which each of the organic HTMs are equally capable of alleviating.