In this paper, a new strategy for voltage balancing of distinct dc buses in cascaded H-bridge rectifiers is presented. This method ensures that the dc bus capacitor voltages converge to the reference value, even when the loads attached to them are extracting different amounts of power. The proposed method can be used for an arbitrary number of series H-bridges, different voltage levels, and different power levels in unidirectional or bidirectional rectifiers. To reduce the current harmonics and distortion, the input current is programmed to be sinusoidal and in phase with the input voltage; however, it is possible to adjust the input power factor to control both the active and reactive powers. In the proposed approach, both the low frequency (stepped modulation) and high frequency [pulse-width modulation (PWM)] switching methods are utilized to improve the performance of the rectifier. Using theoretical analysis, the acceptable load power limits for a rectifier with N-H-bridge cells are derived. The validity of the proposed method is verified by simulation and experimental results.
9 November 2010 in IEEE Transactions on Industry Applications
Today, electromagnetic compatibility (EMC) seems to be one of the major constraints of power electronic converters, particularly for variable-speed drives. Unfortunately, it is too often regarded as the last phase of the development of a converter since it represents the last step of its marketing. The estimation of conducted and radiated disturbances by simulation offers a considerable gain from the economic point of view. This paper shows how relatively simple models can be used to forecast EMC, taking into account various control strategies. These models are validated on an experimental setup and can be used during the design of a variable-speed inverter motor association. The objective is to approach by “fast” simulations the conducted emission to consider optimization processes. It is then imperative to take into account the environment of the converter, which implies the modeling of cables, motors, and, naturally, the filters.
1 March 2013 in IEEE Transactions on Power Electronics
A new approach for easy and fast modeling of EMI filter in aircraft application is proposed, in order to be used in an optimization process. A modular description in a user friendly environment allows describing the model and taking into account all the technological parameters of the system, i.e., the control strategy, the inverter model (semiconductors, layout, etc.), the filter, the cables, and the ac machine. The frequency model is automatically built from this description, as well as its gradients according to its inputs. In a second step, by using this model, an optimization of the filter values can be carried out, using various algorithms, to reach the smallest volume. This early design methodology can also be used to investigate the impact of some technological choices of the electrical drive (control strategy or cable characteristics for instance) on the filter volume.
The design of optimal electromagnetic compatibility filters for converters used in electrical networks requires the precise knowledge of input and output terminal impedances. For this reason, the knowledge of the network impedance, including all connected converters, is determined. This paper proposes a study of both the common mode (CM) and the differential mode (DM) impedances of modern embedded networks including cables and several converters. Using a dc network for illustration, we determine the impedance taking into account all operating states of a converter (online or offline operations). Without any restrictions, a theoretical model is developed to express the CM and DM impedances using a switching function and a Fourier series decomposition. An experimental validation has been carried out in a frequency range from a few Hertz up to 80 MHz. Our model has then been used in a simple network, so as to compute the network impedance. Measurements have confirmed the proposed model accuracy.