This paper describes the results from a centrifuge investigation into the rate dependence of T-bar and ball penetrometer resistance in kaolin. Four T-bar diameters and two ball diameters were installed in kaolin with overconsolidation ratios of 1, 2 and 5 at penetration velocities varying over five orders of magnitude. The penetration resistances are compared with the properties of kaolin as measured in element tests to assist in the development of a framework that describes this resistance over the full velocity range. Consistent trends emerge when the soil viscosity is assumed to affect the penetration resistance in both the partially drained and undrained conditions, enabling the dependence of the T-bar and ball resistances on diameter, velocity and soil characteristics to be quantified.
Soil scour around a shallowly embedded pile can significantly compromise its lateral response, reducing both stiffness and capacity. Estimation of the lateral pile response must take into account both the scour-hole geometry and the overconsolidation effects on the remaining soil. A series of centrifuge model tests with various scour profiles were conducted at a scale of 1:250 to investigate the effects of both local and general scour on the response of a laterally loaded pile. Measured pile moment distributions and force–displacement data at the pile head were used to derive p–y curves quantifying the lateral pile–soil interaction. The p–y curves derived from various scour profiles were compared for equivalent depths below the new scour base, and below the original soil surface. For the general scour cases, the p–y curves for given depths below the post-scour surface are essentially identical to those at the same depths without scour. In contrast, for the local scour cases, the p–y response at a given depth below the scour-hole base is much stiffer than at the same depth below the original soil surface. As a practical approach to evaluate the effects of scour, the concept of an effective soil depth is introduced to determine the corresponding p–y curves for shallowly embedded piles in sand.
1 June 2001 in Journal of Geotechnical and Geoenvironmental Engineering
The paper presents the results from an experimental program carried out at Trinity College Dublin, in which instrumented model piles were jacked into loose dry sand in a large testing chamber. A number of pile installations were carried out to study the effects of in situ stress, diameter, and wall thickness on the behavior of open-ended piles in sand. These indicated that plug stiffness and capacity may be expressed as simple functions of the cone penetration test end resistance and the incremental filling ratio prior to loading. The magnitude and distribution of shear stresses measured on the inner wall are shown to be compatible with existing experimental data and can be related directly to the stress level, interface friction angle, and dilation of the sand at the pile wall. The data are shown to facilitate a better understanding of the factors controlling plug resistance.
A series of lateral tests conducted in a centrifuge on displacement piles in kaolin is used to examine the effects of pile shape, pile end-condition and clay overconsolidation on the lateral load transfer (p–y) curves in soft clay. These experimental tests are supported by finite-element analyses, which examine the responses of the circular, square and H pile sections used in the centrifuge tests. The experimental and numerical results reveal an important effect of pile shape on p–y curves, but no discernible effect of the pile end condition. These results also indicate comparable dependencies of net ultimate pressures on normalised depth and undrained shear strength. The findings enable development of a new formulation for p–y curves in soft clay, which incorporates the effects of pile shape and uses the triaxial compression consolidated undrained shear strength as the reference undrained strength.