5 December 2018 in IEEE Transactions on Microwave Theory and Techniques
A new microstrip balanced-to-unbalanced power divider with dual bandpass filtering response is presented in this paper. The generalized mixed-mode scattering matrix for the filtering balanced-to-unbalanced power divider is derived to guide the design. Differential-mode (DM) dual-band filtering response is analyzed under the odd-mode excitation to show that the frequency ratio (k = f₂/f₁) and bandwidth of these two passbands could be flexibly controlled. For the even-mode excitation, two intrinsic transmission zeros generated by additional open-ended stub are introduced, aiming to achieve the enhancement of in-band common-mode (CM) suppression. In addition, good in-band isolation and port matching are realized by introducing a grounded resistor. To validate the design concept, two prototypes centering at 1 and 2.5 GHz (k = 2.5), as well as 0.76 and 2.75 GHz (k = 3.62) are implemented following the given design procedure. Tested results of the two fabricated circuits, well agreeing with the simulated ones, exhibit high performances in terms of DM response, in-band CM suppression, port-to-port isolation, and port matching.
30 September 2022 in IEEE Transactions on Antennas and Propagation
In this paper, a novel multi-point differential feeding technique is introduced and applied in the design of filtering patch antennas with wide upper stopband. Different from the traditional differential feeding structure, the proposed method has four physical feeding points on the patch. Our analysis results indicate that the proposed feeding approach can not only effectively excite the desired fundamental TM01 mode, but also flexibly allow for elimination of high-order modes by selecting suitable feeding positions. Just relying on this feeding method, unwanted harmonic radiations can be totally removed up to 4 f 0 without any additional elements. For demonstration, a prototype of stacked patch antenna with filtering response has been then designed. With resorting to the proposed feeding scheme, both driven and stacked patches are indeed able to support good excitation of TM01 mode with other harmonics to be suppressed, leading to a wide upper stopband performance. In addition, several radiation nulls are generated in the stopband to improve the filtering selectivity. Measured results agree well with simulated ones, indicating that the designed differential antenna possess enhanced fractional impedance bandwidths, high in-band gains, low cross polarization, as well as intrinsic wide stopband rejection, further verifying the proposed feeding concept.
27 March 2019 in IEEE Transactions on Microwave Theory and Techniques
In this paper, a new self-packaged wideband balun with the high selective bandpass filtering response and impedance transformation characteristic is presented. By virtue of circuit transformations, corresponding two-port equivalent circuit with asymmetrical port impedances is put forward. The analysis results of this two-port network exhibit that the proposed new design is able to achieve a quasi-elliptic equal-ripple response with three transmission poles and four transmission zeros. In addition, the frequency response can be directly determined according to the desired design specifications of impedance transformation ratio k, ripple fractional bandwidth (FBW), and in-band return loss RL. For validation purposes, a demonstrated wideband balun bandpass filter (BPF) working at 2.0 GHz with 50-100-$Ω $ impedance transformation has been implemented by utilizing the multilayer liquid-crystal polymer (LCP) bonded printed circuit board (PCB) lamination technology. Theoretical, simulated, and measured results are recorded in good agreement, well verifying the design method.
21 May 2025 in IEEE Transactions on Microwave Theory and Techniques
This article introduces a new design method for 360° continuously tunable phase shifters (PSs) with wide bandwidth (BW) and low phase error. In this design, the concept of the phase slope circle, combined with a geometric method, is proposed to address the key issue of large phase error in reflective-type PS (RTPS). This method can directly evaluate the phase shift range (PSR) and phase deviation of the continuously tunable PS with respect to the varactor capacitance ${C} _{\text {v}}$ . When its trajectory falls on the equal-phase-slope circle, low phase error can be achieved and vice versa. It offers explicit guidance and well-defined design criteria for realizing wideband RTPSs with large PSR and low phase error. We systematically analyze the existing reflective loads, including the capacitive, single resonated, and multiple resonated loads, and explicitly illustrate their limitations. To attain a large PSR and low phase error, new reflective loads consisting of mixed lumped and distributed resonators are proposed, and the underlying working mechanism of low phase error characteristic has been elucidated. We also put forward a quantitative and efficient design method accompanied by formulas. To verify the design concept, two prototypes of the proposed 180° and 360° wideband continuously tunable PSs were designed, fabricated, and measured. Both the simulation and measured results are in good agreement. To the best of our knowledge, as of now, this is the widest 360° continuously tunable PS featuring low phase error and the simplest control scheme in low-cost printed circuit board (PCB) technology. Merely two dc control lines are required to achieve an uninterrupted phase shift adjustment spanning from 0° to 360° across a wide operating BW of 50%. It also has the advantages of compact size, good impedance matching, and low insertion loss (IL).
3 July 2023 in IEEE Antennas and Wireless Propagation Letters
This letter proposes a directly connected linear antenna array for ultrawideband applications. Firstly, a wideband antenna element based on multimode resonances is proposed. To facilitate direct connection for small array sizes, the mutual coupling between adjacent elements is reduced. Additionally, an extra slot mode is introduced to achieve both band notch property and antenna miniaturization simultaneously. To combat the edge effect of this antenna array, only slight geometry adjustments of periphery elements are required. Finally, to verify the proposed concept, a 1 × 4 array prototype is fabricated and measured. The experimental results are consistent with the simulation ones, obtaining a wide bandwidth of 117% and gain over 10 dBi. Additionally, a band notch at 3.5 GHz with a gain drop to -3.7 dBi is realized.
2 January 2023 in IEEE Microwave and Wireless Technology Letters
In this letter, a new balanced-to-unbalanced (BTU) in-phase power divider with bandpass filtering response is proposed based on 2-D patch resonators. With resorting to the electric field distribution of the fundamental TM $_{01}$ mode in a square patch cavity, the desired out-of-phase input signal and in-phase output signal can be generated and applied for BTU power divider design. In order to attain good bandpass filtering response, two coupled patch resonators with a proper coupling strength in a stacked form are adopted. As such, high isolation between two output ports can be well achieved with the help of two grounded isolation resistors. For verification, a prototype of BTU filtering in-phase power divider working at 4.0 GHz with a fractional bandwidth (FBW) of 13.7% is implemented. Measured results are in good agreement with the simulated ones, confirming the design concept experimentally.