1 June 2018 in Geomorphology
1 February 2006 in Journal of Geophysical Research: Earth Surface
6 August 2004 in Journal of Geophysical Research: Earth Surface
1 June 2018 in Geomorphology
8 February 2017 in Journal of Geophysical Research: Earth Surface
Analysis of hillslope gradient, landscape relief, and channel steepness in the Daxia River basin provides evidence of a transient geomorphic response to base‐level fall on the northeastern Tibetan Plateau. Low‐gradient channels and gentle hillslopes of the upper watershed are separated from a steeper, high‐relief landscape by a series of convex knickzones along channel longitudinal profiles. Downstream projection of the “relict” portions of the profiles implies ~800–850 m of incision, consistent with geologic and geomorphic records of post ~1.7 Ma incision in the lower watershed. We combine optically stimulated luminescence dating of fluvial terrace deposits to constrain incision rates downstream of knickpoints with catchment‐averaged 10Be concentrations in modern sediment to estimate erosion rates in tributary basins both above and below knickpoints. Both sources of data imply landscape lowering rates of ~300 m Ma−1 below the knickpoint and ~50–100 m Ma−1 above. Field measurements of channel width (n = 48) and calculations of bankfull discharge (n = 9) allow determination of scaling relations among channel hydraulic geometry, discharge, and contributing area that we employ to estimate the patterns of basal shear stress, unit stream power, and bed load transport rate throughout the channel network. Our results imply a clear downstream increase of incision potential; this result would appear to be consistent with a detachment‐limited response to imposed base‐level fall, in which steepening of channels drives an increase in erosion rates. In contrast, however, we do not observe apparent narrowing of channels across the transition from slowly eroding to rapidly eroding portions of the watershed. Rather, the present‐day channel morphology as well as its scaling of hydraulic geometry imply that the river is primarily adjusted to transport its sediment load and suggest that channel morphology may not always reflect the presence of knickpoints and differences in landscape relief.
12 November 2018 in Journal of Geophysical Research: Earth Surface
The subglacial processes of abrasion and quarrying are thought to be primarily responsible for bedrock erosion by glaciers. While theory points to sliding speed as the dominant control on abrasion, rates of quarrying are likely scaled by a more complex combination of sliding speed, effective pressure, bed roughness, and short‐term water‐pressure fluctuations. Here we pair a model for quarrying based on statistical characterization of bedrock strength with a model for subglacial hydrology that describes the temporal evolution of cavities under the influence of variations in sliding speed and effective pressure. Using a finite element model, we simulate the evolution of the hydrological system at the base of a glacier and compute rates of abrasion and quarrying. Cavity lengths and channel cross sections evolve through time, causing temporal shifts in ice‐bed contact area, which in turn govern the differential stress that influences erosion over the course of a year. Our results demonstrate how variations in meltwater production amplify rates of subglacial erosion relative to the case of steady meltwater generation. The level of amplification depends on how the variations control the ice‐bed contact area. Seasonal variations are most effective in boosting mean rates of basal sliding and hence subglacial abrasion, whereas shorter‐term variations (monthly‐weekly) most strongly influence rates of subglacial quarrying through temporal amplification of differential bedrock stress around cavities. This influence of transient hydrology on subglacial erosion processes may explain why glaciers in temperate climates with strong variations in temperature and precipitation erode faster than similar‐type glaciers in polar environments.