8 September 2023 in Optics Letters
Long-range vibration sensing is an important tool for real-time structural health monitoring. A new, to the best of our knowledge, design of a distributed fiber-optic vibration sensor is introduced and experimentally demonstrated in this study. The proposed system utilizes the transmission of light in the forward direction for sensing, and a self-interference method for laser source simplification. To extract vibration information from phase modulation of light, two Mach–Zehnder interferometers (MZIs) are employed with a 3 × 3 coupler-based differential cross multiplication algorithm for phase calculation. A folded double-ended detection configuration allows the time-of-flight difference via cross correlation (CC) to provide vibration positioning. Experimental results demonstrate a sensing range of up to ∼80 km without optical amplification, accompanied by a position accuracy of 336 m.
7 May 2024 in Journal of Lightwave Technology
Undersea earthquakes can have a major impact on coastal cities, submarine infrastructure and environment. To provide advance warning and condition assessment, remote monitoring is critical. However, the current methods of undersea earthquake monitoring have some limitations, such as limited number of sensors, high deployment cost, severe signal attenuation, etc. In this study, we propose a new approach for super-long range vibration monitoring, by detecting vibration-induced phase change along a single sensing fiber using a double-ended forward-transmission distributed fiber-optic vibration sensing system with a compensated self-interference sensing mechanism. The experiment results show a single-span sensing range of 151.5 km without optical amplification, a spatial resolution of 10 m, and the position error can be as small as 37.6 m. The average sensitivity is ∼12.2 mrad/μϵ, and the average limit of detection is 186.7 pϵ/Hz1/2. The vibration frequency range tested is between 100-500 Hz. The sensing system has several advantages, such as super-long sensing distance, relatively low-coherence laser, anti-electromagnetic interference, etc. This study provides a new technical solution for undersea earthquake monitoring, which can improve the early warning and assessment capabilities of undersea earthquakes.
4 December 2023 in Journal of Lightwave Technology
Distributed fiber-optic sensors are widely used for mining safety monitoring, civil engineering structural health monitoring and environmental monitoring. The position accuracy of measurements is of critical concern, as errors can lead to expensive decisions at the wrong location. Accurate fiber length measurement is key to calibrate distributed fiber-optic sensors. Existing methods suffer from time resolution or component delay errors. Optical time-domain reflectometry (OTDR) and its variants are widely used but needs calibration for practical applications. We propose two new methods that can self-calibrate, and can be used to calibrate other methods such as those based on OTDR. One based on a differential pulse loop using dual pulse statistical signal processing, and another is based on a differential pulse loop with multi-pulse sequence analysis, to enhance the timing accuracy. In addition, it is possible to determine the effective index of a single-mode fiber with known fiber length, which is important prerequisite information for practical applications in the field with uncertain laser wavelength and ambient temperature. When using a low-end oscilloscope with a nominal 26 MS/s sampling rate, compared with the measurement results of optical frequency domain reflectometer (OFDR) (LunaOBR4600), the double pulse method has an error of ±6 cm. For the multi pulse method, the measurement error can be as low as 1.75 mm for a fiber length of 2.049 km (relative error of 8.54 × 10 −7 ).