Nickel‐molybdenum (NiMo) alloys can be a possible alternative to platinum as hydrogen evolution reaction (HER) catalysts because of the superior HER activity. However, the superior HER activity and the pH‐dependent kinetics are not currently fully understood. Herein, we present a study of HER kinetics and mechanisms of NiMo in alkaline, near‐neutral and acidic media by combining voltammetry measurements with electrochemical impedance spectroscopy and a microkinetic model. The results indicate that, compared to Ni, NiMo has significantly higher active surface area and intrinsic HER activity. In the subsequent measurements, we demonstrated that different from the existing explanations to the HER mechanisms for NiMo, the HER process in acidic, near‐neutral, and alkaline media is controlled by the Heyrovsky step. Our results show that increasing pH increases the hydrogen coverage, which increases the Tafel‐slope at low overpotentials, eventually resulting in only a single Tafel slope, which would commonly be interpreted as a Volmer‐limited reaction. Furthermore, the studies of thickness effect on HER kinetics show that the HER kinetics of NiMo are thickness‐dependent. In phosphate buffer, the increase in thickness did not significantly increase the double‐layer capacitance, but simulations with the microkinetic model indicate that the active surface area still increased similarly to other electrolytes, which is likely related to the type of electrolyte used.
The recent surge in investigating electrocatalysts for the H2 evolution reaction is based on finding a cheap alternative to Pt. However platinum's excellent catalytic activity means very little catalyst needs to be used. The present study combines model experiments with numerical modeling to determine exactly how little catalyst is needed. Specifically we investigate ultra-low Pt loadings for use in photoelectrochemical H2 evolution using TiO2–Ti-pn+Si photocathodes. At a current density of 10 mA cm−2, we photocathodically evolve H2 at +465, +450, +350 and +270 mV vs., RHE at Pt loadings of 1000, 200, 50, and 10 ng cm−2 corresponding to HER overpotentials of η1000ng = 32 mV, η200ng = 46 mV, η50ng = 142 mV, and η10ng = 231 mV. To put this in perspective, if 30% of the world's current annual Pt production was used for H2 evolution catalysis, using a loading of 100 ng cm−2 and a current of 10 mA cm−2 would produce 1 TWaverage of H2. The photoelectrochemical data matched the modeling calculations implying that we were near the fundamental maximum in performance for our system. Furthermore modeling indicated that the overpotentials were dominated by mass transfer effects, rather than catalysis unless catalyst loadings were less than 1000 ng cm−2.
Direct solar hydrogen generation via a combination of photovoltaics (PV) and water electrolysis can potentially ensure a sustainable energy supply while minimizing greenhouse emissions. The PECSYS project aims at demonstrating a solar‐driven electrochemical hydrogen generation system with an area >10 m2with high efficiency and at reasonable cost. Thermally integrated PV electrolyzers (ECs) using thin‐film silicon, undoped, and silver‐doped Cu(In,Ga)Se2and silicon heterojunction PV combined with alkaline electrolysis to form one unit are developed on a prototype level with solar collection areas in the range from 64 to 2600 cm2with the solar‐to‐hydrogen (StH) efficiency ranging from ≈4 to 13%. Electrical direct coupling of PV modules to a proton exchange membrane EC to test the effects of bifaciality (730 cm2solar collection area) and to study the long‐term operation under outdoor conditions (10 m2collection area) is also investigated. In both cases, StH efficiencies exceeding 10% can be maintained over the test periods used. All the StH efficiencies reported are based on measured gas outflow using mass flow meters.
17 May 2012 in The Journal of Physical Chemistry C