11 September 2019 in IEEE Sensors Journal
Misalignment of wireless power transfer (WPT) system’s transmitting and receiving ends can cause severe efficiency degradation and electromagnetic radiation. In this paper, a novel parallel transmission (TX) coil matrix structure was proposed to improve the performance of the WPT in the misalignment condition. The receiving (RX) coil’s position measurement method was innovated by investigating the magnetic field and the mutual inductance change caused by the relative position change between RX and TX coils. Both theory and experiments confirmed that the phase difference between signal coil and detector coil can be featured as the parameter to represent the magnetic field’s change. Based on this principle, a 4×4 TX coil matrix was made which verified the proposal and the sensitivity of the sensor. It was found that the position measurement result was sufficient to decide which TX coil to gate to facilitate the wireless charging in misalignment conditions. The structure and the size of the TX coil matrix could be further optimized to enhance the sensor’s reliability and sensitivity.
10 September 2024 in IEEE Transactions on Dielectrics and Electrical Insulation
Online measurement of transient voltages is crucial for maintaining the reliability and safety of AC power systems. With the construction of UHV/EHV AC power systems, the voltage levels of AC equipment continue to increase, and traditional capacitor voltage dividers (CVD) become unreliable due to the instability of their ground capacitance. This article proposes an equipotential shielding capacitor voltage divider and conducts simulation research on its measurement characteristics. The results show that a stable measurement can be guaranteed when the distance to the ground is greater than 10 times the diameter of the measuring spherical conductor. The equipotential shielding capacitor voltage divider (ES-CVD) can effectively prevent the electric field strength on the surface of the measuring spherical conductor from exceeding the critical discharge field strength. The high-voltage wire to be measured and adjacent high-voltage wires have a significant impact on the ground capacitance of the measuring spherical conductor. However, the shielding electrode can significantly reduce their impact. Compared to a CVD without a shielding electrode, a divider with a shielding electrode can reduce the measurement error by one order of magnitude which meets the measurement requirements of transient voltage. The research results in this paper can provide a reference for measuring high-voltage AC transient voltage.
18 November 2023 in Heliyon
The multi-target data association method is studied in order to realize multi-target tracking in infrared fish-eye warning system. The Neural Joint Probabilistic Data Association (NJPDA) algorithm is analyzed. It is found that the NJPDA algorithm only considers the distance information between the measurement and the target in the data association process, and its tracking accuracy needs to be further improved. Therefore, a new method fused with direction information is proposed based on the NJPDA algorithm. The proposed algorithm defines the concept of direction difference, introduces the direction information of target motion, and modifies the likelihood function by Gaussian weighting method, so as to fuse the direction information of target motion into the calculation of data interconnection probability. Experimental results demonstrate that the tracking success rate of the proposed algorithm is nearly 10 % higher than that of JPDA and NJPDA algorithms and its consuming time meets the real-time requirement of the infrared fish-eye warning system.