1 January 2024 in Physics of Fluids
The heat release process in a rotating detonation combustor (RDC) exhibits highly transient characteristics, posing significant demands on the thermal protection and management of the rotating detonation engine (RDE). In this work, the wall heat transfer characteristics of the RDC supplied by H2/air were experimentally examined with different equivalence ratios, mass flow rates, and initial wall temperatures. High-speed photography and dynamic pressure transducers were used to determine the propagation mode of the rotating detonation wave, while the wall temperature and heat flux were monitored by thermocouples. The results showed that the wall temperature and heat flux decreased along the axial direction. A parabolic temperature variation occurs when equivalence ratio increases from 0.8 to 1.3, and the extreme value appears at Φ = 1.2. The same trend happens between heat flux and equivalence ratio. The mass flow rate increase leads to the overall increase in the temperature and heat flux, with the spatial distributions remaining unchanged. The higher initial wall temperature leads to the increase in the combustor outer wall temperature, a reduction in the spatial variation of temperature distribution, a decrease in heat flux, and a reduction in the spatial variation of heat flux. Furthermore, an empirical model was developed to estimate the heat transfer characteristics. Valid calculations show that the temporal and spatial temperature function results in lower errors of peak temperature prediction by approximately 50% and higher spatial resolution compared to a constant heat flux boundary condition. The research findings provide a theoretical foundation for the RDE thermal protection issues.
1 March 2026 in Physics of Fluids
Film cooling over curved surfaces subjected to variable pressure gradients exhibits complex near-wall flow dynamics, which are strongly influenced by the local pressure gradient distribution and the mainstream flow structure. In this study, the film cooling response of different hole geometries on a single curved surface exposed to a highly nonuniform three-dimensional mainstream is investigated using numerical simulations, with particular emphasis on the coolant-to-mainstream pressure ratio (RP). The upstream region is dominated by a strong adverse pressure gradient (SAPG), which suppresses coolant discharge, induces near-wall recirculation, and leads to unstable and direction-sensitive jets' behavior for cylindrical holes. As RP increases, several holes remain susceptible to jet bifurcation, lift-off, and reverse entrainment, indicating the limited effectiveness of increasing RP alone. Analysis of boundary layer characteristics and coolant trajectories reveals three distinct flow-response modes: attached plate-like jets under mild adverse or favorable pressure gradients, forked distributions caused by separation and reattachment under moderate adverse pressure gradients, and reverse entrainment under SAPG conditions. Based on these mechanisms, two modified hole geometries—a racetrack-shaped (RS) hole and a forward-inclined fan-shaped hole—are proposed. Both geometries stabilize the coolant trajectory and mitigate SAPG-induced recirculation, with the RS hole providing the most robust near-wall attachment under SAPG conditions.