A curvature-compensated resistor-less bandgap reference (BGR), which is fabricated in 0.5-μm CMOS process, is proposed in this paper. The BGR utilizes successive voltagestep compensation to produce a temperature-insensitive voltage reference (VR), including one AVGS step for first-order compensation and another one for higher order curvature correction. Moreover, a supply noise bypassing technique is adopted to achieve good power supply rejection performance up to high frequency. Experimental results demonstrate that this BGR is able to produce a VR of 1.196 V with a temperature coefficient of 3.98 ppm/°C at 3.6-V supply voltage. A power-supply noise attenuation of -84 dB@100 Hz and -37 dB@100 kHz are easily achieved, and the line regulation is better than 0.19 mV/V when supply voltage varies from 2.1 to 5 V. The proposed reference occupies an active area of 356 μm × 150 μm and consumes a quiescent current of 38 μA.
1 January 2016 in Academy of Management Proceedings
With the higher proportion of renewable energy generation connected to the grid, the frequency stability of power system faces greater challenge. Utilizing demand response (DR) technology for frequency regulation has become a new and effective method. Among various kinds of demand side resources, there are some natural advantages for the thermostatically controlled loads (TCLs) due to their high proportion in the total load and capability of storing thermal energy, which makes short-term regulation will not affect the user's electricity consumption comfort. This paper takes inverter air-conditioners as typical TCLs to establish time-frequency domain model and evaluate the potentiality of TCLs for providing frequency regulation service. Then, the significance of TCLs participating in frequency regulation on the frequency stability of power system is analyzed by simulation. Finally, a hybrid control method considering user's electricity consumption comfort for large-scale TCLs participating in power system frequency regulation is proposed.
Accurately quantifying the uncertainty brought by distributed generation (DG) is very important for the safe and stable operation of power grid. Uncertainty is mainly divided into randomness and fuzziness. Traditional model of DG only considers its randomness, neglecting the influence of fuzzy parameters and fuzzy correlation, which sometimes leads to analysis results deviating from objective facts. To deal with this problem, an uncertainty quantification method considering both random and fuzzy characteristics of DG is proposed in this paper. Firstly, a DG model that considers the random and fuzzy parameters, as well as fuzzy correlation is established. Then, based on Nataf transform and point estimation method, probabilistic load flow is carried out in different membership degrees. And global sensitivity analysis based on membership function is applied for discussing the contribution to the output response of each fuzzy parameter. Finally, modified IEEE 33-bus and IEEE 118-bus systems are used for simulation. The results show that DG model considering both randomness and fuzziness can more scientifically depict the impact of uncertainty.