We present an experimental and computing analysis of the nonlinear distortions of an all-optical radiofrequency mixer based on cross-gain modulation (XGM) in a semiconductor optical amplifier (SOA). Such an all-optical mixer is well suited for radio-over-fiber (RoF) applications. The simulation results are based on a SOA model developed under ADS™ software and are compared to experimental results in various cases. The good correlation between experimental and simulation results permits to demonstrate the ability of our SOA model to study mixing phenomenon by using a Harmonic Balance (HB) simulation method. Optical third-order input intercept point (IIP3) and its electrical equivalent are determined experimentally and by simulation with a good concordance. An optical IIP3 of -5 dBm and a spurious free dynamic range (SFDR) of 85.7 dB/Hz are obtained for a radiofrequency signal at 1 GHz. Moreover, simulations show that the IIP3 increases, all other parameters being equal, when the SOA active zone is shortened.
We experimentally and theoretically demonstrate the semiconductor optical amplifier (SOA) gain recovery-time (RT) dependence on the probe signal wavelength and power when injecting a continuous-wave high-power assist light in the device. In our paper, pump, probe, and assist-light waves are all copropagative. Experimental and numerical results show that the gain RT is significantly reduced over a wideband of probe wavelengths due to the assist-light use. The reduction is more pronounced for low probe powers. A theoretical evaluation of the transparency-wavelength dependence on both the probe wavelength and power is presented. Then, a study on assist-light power effects on the SOA dynamics as well as pump- and probe-wavelength effects on SOA gain RT is performed
The feasibility of employing a birefringent fiber loop to enhance the performance of a directly modulated reflective semiconductor optical amplifier is experimentally demonstrated for the first time. The birefringent fiber loop acts as an optical filter of opposite slope than that of the reflective semiconductor optical amplifier electro-optical response and counteracts the finite reflective semiconductor optical amplifier modulation bandwidth of only 0.89 GHz. By proper adjustment of its detuning, the birefringent fiber loop tailors the spectral components that physically manifest due to the reflective semiconductor optical amplifier dynamic perturbation subject to direct modulation in the saturated gain regime, and suppresses the pattern-dependent distortions in the time domain. In this manner, the birefringent fiber loop manages to significantly improve the quality characteristics of the encoded signal at higher data rates than those enabled by the reflective semiconductor optical amplifier limited modulation capability. Owing to the birefringent fiber loop, the reflective semiconductor optical amplifier modulation range is extended to 4 Gb/s at the raw bit error rate of , and to 11 Gb/s at the forward error correction limit of . These results, which are unique against the evaluation criterion adopted in the first case, and the modulation speed achieved with post-filtering schemes in the second, highlight the beneficial role that the birefringent fiber loop can play in supporting reflective semiconductor optical amplifier operation for intensity amplification and modulation purposes.
5 August 2003 in Microwave and Optical Technology Letters
With the emergence of the Future Internet and the dawning of new IT models such as cloud computing, the usage of data centers (DC), and consequently their power consumption, increase dramatically. Besides the ecological impact, the energy consumption is a predominant criteria for DC providers since it determines the daily cost of their infrastructure. As a consequence, power management becomes one of the main challenges for DC infrastructures and more generally for large-scale distributed systems. In this paper, we present the EPOC project which focuses on optimizing the energy consumption of mono-site DCs connected to the regular electrical grid and to renewable energy sources.
9 January 2012 in IEEE Photonics Technology Letters
Experimental results of using a semiconductor optical amplifier (SOA) for amplification of a coherent optical-orthogonal frequency-division-multiplexing (CO-OFDM) transmission system are presented. The impact of the SOA nonlinearities on the amplification of a 10.94-Gb/s quadrature phase-shift keying CO-OFDM signal with respect to the input power, the signal wavelength, and the number of subcarriers is investigated.