19 November 2020 in IEEE Transactions on Circuits and Systems I: Regular Papers
In many sensor applications, a high-resolution analog-to-digital converter (ADC) is a key block. The use of an incremental delta-sigma ADC (IADC) is often well suited for such applications. While the energy-efficiency of IADCs has improved by several orders of magnitude over the past decade, the implementation of high performance IADCs, especially in battery-powered systems, is still challenging. This paper presents a tutorial review on energy-efficient IADCs and addresses the progress in this area. This paper describes the fundamentals of IADCs and energy-efficient hybrid IADC architectures. Various design techniques for improving the energy-efficiency of the IADCs are described. This paper is intended to serve as a starting point for the development of a new energy-efficient IADC.
27 July 2021 in IEEE Transactions on Circuits and Systems I: Regular Papers
A novel active noise-shaping SAR ADC with on- chip digital DAC calibration is presented. To relax the design of the single op-amp used as an integrator, correlated double sampling (CDS) and correlated level shifting (CLS) were implemented. CDS minimizes the offset of the integrator and reduces the flicker noise, while CLS boosts the gain of the op-amp and reduces the power consumption. Also, a two-step incremental ADC based digital DAC calibration scheme was implemented to cancel the DAC mismatch errors and parasitics effects. The ADC was fabricated in 0.13 $\mu \text{m}$ CMOS technology. It achieved 85.1 dB DR, 82.6 dB SNDR and 90.9 dB SFDR within a 2 kHz signal bandwidth with an oversampling ratio OSR = 32. It consumes 40.8 $\mu \text{W}$ power using a 1.6 V power supply.
5 November 2019 in IEEE Transactions on Circuits and Systems I: Regular Papers
A highly reconfigurable charge-domain switched-gm-C biquad band-pass filter (BPF) topology that utilizes an interleaved semi-passive charge-sharing technique is proposed. It uses only switches, capacitors, linearity-enhanced gm-stages and digital circuitry for a 3-phase non-overlapping clock scheme. Flexible tunability in both center frequency and -3dB bandwidth is achieved with a scaling-compatible implementation. A 4th-order BPF prototype operating at a 1.2GS/s sampling rate is designed with a cascade of two reconfigurable biquad stages in a 65nm LPE CMOS process. A tunable center frequency of 35-70MHz is measured with programmable bandwidths and a maximum stop-band rejection of 72dB. The measured in-band IIP3 is +12.5dBm. The filter prototype consumes 7.5mW total power from a 1.2V supply voltage, and occupies an active area of 0.17mm².
16 March 2020 in IEEE Transactions on Circuits and Systems I: Regular Papers
Slewing in switched capacitor (SC) circuits reduces the available time for linear settling, and hence increases the nonlinear settling error. This transient demand in current can be supplied by making the bias currents larger in the operational transconductance amplifier (OTA). However, this increases the static power consumption significantly. In this paper a slewing mitigation technique is presented where just the right amount of charge is provided at the switching instant to the SC circuit so that OTA does not need to provide high peak current. This may eliminate slewing altogether, and allows using OTAs with less static current for the same settling accuracy. The operation of the proposed technique is illustrated by incorporating it in a second-order delta-sigma modulator (DSM). The modulator was designed and simulated in a 65nm CMOS process. Post-layout extracted simulations with optimized design show more than 12 dB improvement in signal to noise and distortion ratio (SNDR) for the same static power. Alternatively, compared to a DSM without such technique, the same performance can be achieved with 30% less power.