Antibiotics are used extensively throughout the world and their presence in the environment has caused serious pollution. This review summarizes natural methods and enhanced technologies that have been developed for antibiotic degradation. In the natural environment, antibiotics can be degraded by photolysis, hydrolysis, and biodegradation, but the rate and extent of degradation are limited. Recently, developed enhanced techniques utilize biological, chemical, or physicochemical principles for antibiotic removal. These techniques include traditional biological methods, adsorption methods, membrane treatment, advanced oxidation processes (AOPs), constructed wetlands (CWs), microalgae treatment, and microbial electrochemical systems (such as microbial fuel cells, MFCs). These techniques have both advantages and disadvantages and, to overcome disadvantages associated with individual techniques, hybrid techniques have been developed and have shown significant potential for antibiotic removal. Hybrids include combinations of the electrochemical method with AOPs, CWs with MFCs, microalgal treatment with activated sludge, and AOPs with MFCs. Considering the complexity of antibiotic pollution and the characteristics of currently used removal technologies, it is apparent that hybrid methods are better choices for dealing with antibiotic contaminants.
6 September 2016 in Journal of Material Cycles and Waste Management
Background There has been limited research considering the effects of prenatal exposure to multiple heavy metals on early childhood size and growth. Objective We evaluated prenatal exposures to 15 heavy metals in association with measures of weight, length, and head circumference (HC) measured at birth, and 1, 3 and 6 months of age in a study of 358 mother-child pairs. Methods Urinary concentrations were measured in the first and third trimesters of pregnancy and examined, using sex-stratified general linear models, in association with average standardized size and changes in size (growth) over the first 6 months of life. Confounding effects among metals were explored. Results Increased first trimester Hg and V were associated with decreased average HC among males and weight among females, respectively. Increased first trimester V was associated with a decline in weight among females over time. Increased third trimester Cs, Rb and Tl were associated with increased average weight and HC among males. Increased third trimester Se was associated with increased HC among females over time. Evidence for confounding was observed between Cs, Rb and Tl in association with weight and HC. Significance We observed multiple biologically plausible associations between prenatal heavy metal exposures and postnatal size and growth. Impact We have taken a comprehensive and novel approach to evaluating the impacts of prenatal heavy metal exposures on size and growth during early childhood. Our detailed analyses consider exposures to 15 different heavy metals at two time points during pregnancy, as well as multiple metrics of size and growth collected at birth and 1, 3 and 6 months of age.
The quantitative evaluation of azelaic acid is becoming critical in the development of new medicinal products and in environment. A feasible method for the determination of azelaic acid in cosmetics by gas chromatographic-mass spectrometer detector (GC-MS) with derivation was developed and optimized. The derivative effect was good, when azelaic acid was derivatized through ethanol at room temperature for 10 min with 800 μL of sulfuric acid as a catalyst. A good linear relationship of azelaic acid derivative was present from 10 to 1000 mg L-1 (R2 = 0.9997). Detection limit and quantitative limit of GC was 15 and 50 mg kg-1, respectively. The recovery rate was in the range from 87.7% to 101% with all relative standard deviation (RSD) values less than 4%, denoting the method meeting the requirement of the analysis. Therefore, this method has the advantages of strong anti-interference ability and accurate results. Among the eight samples nominally azelaic acid, only three were detected. The respective content was 78 133, 16 710, and 2431 mg kg-1. The results showed that the actual addition of the azelaic acid in the market was quite different with label identification, being worthy of further attention. Further, it also provided a favorable experience for the monitoring of azelaic acid in the environment.
19 October 2021 in International Journal of Environmental Science and Technology
In previous work, a methodology was developed to discuss the influence of meteorological factors, policies, and surrounding cities on PM2.5 concentrations in a city. Two models were constructed using Zibo City, Shandong Province, as the target city. Initially, we improved the established PM2.5-Meteorological-Policy (PMP) model and applied it to six other target cities in Shandong Province. Concurrently, a novel model named the PM2.5-Interregional (PI) model was further developed in each city to directly express the influence of surrounding cities on the target cities. The model construction period was from January 2014 to August 2022, with the extended prediction period until November 2022. The results confirmed that disparities in the spatial distribution in seasons became smaller after the implementation of environmental policies. Moreover, two models in each city revealed good interpretation with high adjusted R2 values (>0.7) and lower MAPE and RMSE values (the lowest was 5.53% and 2.57), suggesting reasonable short-term prediction. Additionally, meteorological factors and the combined implementation of different policy types played crucial roles in reducing PM2.5 concentrations in all cities. Specifically, the temperature and wind speed were negatively correlated with PM2.5 concentrations in all models, with temperature having a stronger influence. The Law of the People's Republic of China on the Prevention and Control of Atmospheric Pollution (LAPAP), implemented in 2016, had a clear influence on reducing PM2.5 concentrations, with the highest absolute fitted coefficient in most cities (-0.166 to -0.344). On the contrary, the influence of temperature seemed to be more significant compared to policies, due to the larger standardized coefficient in each city (-0.606 to -0.864).