Analog weight cells based on ferroelectric field-effect transistors (FeFETs) are promising for fast and energy efficient compute-in-memory (CIM) accelerators, yet their on- chip training is hindered by the limited linearity and endurance. To address this critical issue, we introduced a novel FeFET design featuring a hybrid ferroelectric layer of Hf0.5Zr0.5O2 and Hf0.95Al0.05O2 with Al2O3 interlayers. The proposed FeFET achieves a high linearity of $\alpha _{\text {p}}= -0.48$ and $\alpha _{\text {d}}= -1.73$ , good endurance of over $10^{{9}}$ cycles, and a fast switching speed of ~50 ns. The mechanism of such improvement was probed carefully by comparison with control devices. The benefit of device optimization was experimentally demonstrated by performing an on- chip training task on a 1T NOR array, and the system-level benchmarking of the CIM accelerator based on our FeFET shows an overall superior performance. This work contributes to the development of FeFETs for on- chip neuromorphic hardware.
13 September 2024 in IEEE Transactions on Electron Devices
Hafnium oxide (HfO2)-based ferroelectric (FE) field-effect transistor (FeFET) is considered as one of the most promising candidates for future embedded non-volatile memory (eNVM). However, the application of HfO2-based FeFET is still limited by the high operating voltage and poor endurance. To address these problems, we developed a novel co-optimization design of the FE layer and the interlayer (IL) in the FeFET gate-stack. In the proposed Hf0.95Al0.05O2 (HAO) + Al2O3 structure, the conventional zirconium-doped HfO2 (HZO) is replaced by HAO, which has a smaller coercive field to reduce the bias stress, while the IL is optimized by replacing the SiOx formed by oxygen diffusion with a high-quality atomic layer deposition (ALD) Al2O3 layer to mitigate charge trapping and FE depolarization. We achieved an overall improvement in memory performance, resulting in a low operating voltage of +4 V, $1\mu $ s and −3 V, $2~\mu $ s, high endurance of more than $10^{{9}}$ cycles, and retention time of over ten years at room temperature. This work helps push forward the development of low voltage and high endurance FeFETs.
Multi-level cell (MLC) ferroelectric FETs (FeFETs) face critical reliability challenges including variation, endurance and write disturb. In this work, we proposed an innovative solution to tackle all the three challenges within a compact writing scheme. Combining error correction, endurance recovery, and self-compensated writing, the proposed scheme achieves a > 6× reduction in error ratio (ER), a > 100 improvement in endurance, and a > 7× reduction in Vth shift. Reliable 2 bits/cell storage with high endurance of 108 cycles and write-disturb immunity is experimentally demonstrated in the fabricated 1T FeFET array. This writing scheme is realized within a single work flow, and can be readily implemented in the operation circuits.
FeMFET is a promising non-volatile memory technology, but in-depth study of the device is complicated by the coupling between polarization switching (PS) and charge trapping (CT). In this work, we developed a novel analysis method by correlating dynamic middle electrode voltage (Vmid) with the DC component of drain current. The extracted Vmid enables accurate charge calculation in the FE capacitor and the transistor part, thus decoupling the PS and the CT process during device writing. The dynamic PS and CT results provide insights into the spatial and temporal properties of interlayer traps, further enabling quantitative modeling of traps with multi-perspective consistency, including trap charges, Id-Vg and MW. The model uniquely identifies the HfO2 trap energy level at 2.25±0.08 eV below Ec, consistent with other works based on photo-depopulation method or MOSFET BTI reliability analysis. This work offers a novel approach to investigating and modeling the key processes in FeFETs.
1 July 2026 in IEEE Transactions on Electron Devices