30 August 2016 in IEEE Transactions on Plasma Science
Megavolt-class-triggered switches play a key role in large-induction voltage adder accelerators. This paper introduces a 2.8-MV, low-inductance, low-jitter, electrical-triggered, gas SF6 switch. The main section is a V/n switch and the pretrigger section is a trigatron switch. Based on electric field simulation, experiment, and analysis, the structure and spacing of gaps, location of trigger disk, diaphragm, and switch inductance are all discussed. The primary test indicates that the switch can be operated in the range of 0.85-2.76 MV with the pressure of the SF6 changing from 0.1 to 0.9 MPa. The self-breakdown voltage is linearly related to the logarithm of the pressure, as the gap spacing and the voltage rise time are fixed. Three working modes were observed: self-breakdown, self-triggered, and ex-triggered. In the triggered modes, the switch jitter is <;3 ns and the switch inductance is usually below 150 nH.
25 August 2014 in IEEE Transactions on Dielectrics and Electrical Insulation
This paper gives the initial consideration of using glycerin medium to substitute the transformer oil widely used in present cells of magnetically insulated inductive voltage adders (MIVA). The effects of different mediums on MIVA performances such as electric field distribution, feed current uniformity, and cell output voltage, are simulated and compared. The simulation results indicate that, in case of four pulses driving simultaneously, the cells insulated by glycerin would output a pulse with the peak voltage increasing by about 8%. However, in case of four pulses driving separately, as replacing transformer oil with glycerin, the peak voltage of cell outputs decreases by 9%, and risetime increases dramatically from 32 ns to 59 ns. For the encountered issues caused by the glycerin medium, some solution methods are presented, and the feasibility of utilizing glycerin in MIVA cells is discussed.
1 April 2011 in Plasma Science and Technology
1 June 2026 in Review of Scientific Instruments
Stable capacitance in the transfer capacitor is crucial for ensuring a reliable output waveform from the high-altitude electromagnetic pulse simulator. Different types of environmental stress pose significant challenges for the performance and reliability of the outdoor simulator and its transfer capacitors. This paper presents a preliminary investigation on the effects of temperature and mechanical stress on both the capacitance of the transfer capacitor fabricated with the polypropylene film and the simulator’s output waveform. Experiments reveal that the capacitance exhibits an approximately linear increase with temperature, reaching a maximum variation of 6.3% at 60 °C. It increases with the heating time and stabilizes after ∼1 h, and the capacitance change under thermal stress is reversible. The capacitance variation remains within 0.22% under the steady-state vibrational stress, whereas it decreases by ∼2.04% with an increasing number of hammer strikes. It is demonstrated that the fluctuation of capacitance caused by the thermal or mechanical stress would result in a deviation of the waveform for the simulator under the parameters in this study. These findings will enhance the understanding of the characteristics of the transfer capacitor under mechanical or thermal stress, thereby facilitating future optimization and rational maintenance of the capacitor with this structure.