Megavolt-class-triggered switches play a key role in large-induction voltage adder accelerators. This paper introduces a 2.8-MV, low-inductance, low-jitter, electrical-triggered, gas SF6 switch. The main section is a V/n switch and the pretrigger section is a trigatron switch. Based on electric field simulation, experiment, and analysis, the structure and spacing of gaps, location of trigger disk, diaphragm, and switch inductance are all discussed. The primary test indicates that the switch can be operated in the range of 0.85-2.76 MV with the pressure of the SF6 changing from 0.1 to 0.9 MPa. The self-breakdown voltage is linearly related to the logarithm of the pressure, as the gap spacing and the voltage rise time are fixed. Three working modes were observed: self-breakdown, self-triggered, and ex-triggered. In the triggered modes, the switch jitter is <;3 ns and the switch inductance is usually below 150 nH.
16 March 2009 in Journal of the American Ceramic Society
Ceramic solid solutions (1-x)(Bi0.9Nd0.1)(Sc0.9B0.1)O3 - xPbTiO3 (x = 0.60–0.66; B - Lu, Yb, Er, Y) based on the compositions close to the morphotropic boundary, have been prepared. To improve the phase content and the resistance of ceramics, Bi2O3 and MnO2 additives were used. Phase composition, structure, microstructure, phase transitions, ferroelectric and piezoelectric properties have been studied. The 1st order ferroelectric phase transitions are marked by peaks near 700–750 K in dielectric permittivity and dielectric loss temperature dependences. Effect of dielectric relaxation was observed, its relation to composition of ceramics determined. The Curie temperature TC increase was observed with increasing the PbTiO3 constituent, while the TC decrease is typical of the A- or B-cations doped compositions. Introduction of MnO2 and/or Bi2O3 additives lead to the decrease of total conductivity and dielectric losses to more than one order at elevated temperatures. Enhanced d33 and kt values were measured in modified ceramics.
1 August 2011 in Bulletin of the Russian Academy of Sciences: Physics
The ferroelectric and piezoelectric properties of ceramic solid solutions having a composition of (1−x)(Bi0.9Nd0.1)(Sc0.9B0.1)O3 − xPbTiO3 (x = 0.60–0.66; B = Lu, Yb, Er, Y) and obtained by solid state reaction were studied. An increase in the Curie temperature was found upon an increase in the concentration of lead titanate, while a drop occured upon the doping of the A and B sublattices. It was shown that at high temperatures, MnO2 and Bi2O3 additives lead to a reduction in the total conductivity and a dielectric loss of less than one order of magnitude. In modified ceramics, an increase in the d33 and kt piezoelectric coefficients was observed as well. The effects of dielectric relaxation that are determined by the composition of the ceramics were revealed.