28 February 2025 in Technology audit and production reserves
The object of the research is technological processes, seeds and kernels of industrial hemp, centrifugal dehullers, dehuller impellers. The research is aimed at increasing the efficiency of centrifugal dehulling of industrial hemp seeds by determining the influence of the number of profile holes in the impellers. Two variants of the impeller design were developed and tested: with four and six profile holes. The research was conducted on seeds of the “Glesia” variety under stable processing conditions, including optimal humidity (8.4 %) and standardized wheel rotation parameters (6000±200 rpm). According to the research results, it was established: – an impeller with four profile holes in five dehulling cycles enabled a total kernel yield of 34.81 %. Under such conditions, the bulk of the seeds were dehulled in the first three cycles; – the impeller with six profile holes made it possible to ensure a total kernel yield of 34.48 % in three dehulling cycles. Under these conditions, a significant part of the kernels was separated in the first two cycles. According to the results of the analysis of the dehulling indicators, it was noted: – in the first two cycles, the wheel with six holes separated up to 29.71 % of the kernels, and the wheel with four holes - up to 22.02 %; – the use of the design of the wheel with six holes reduced the remains of undehulled seeds after the third cycle to 4.24 % of the initial mass, while the wheel with four holes – up to 16.23 %. The advantages of the centrifugal dehulling method, which is based on the principle of converting kinetic energy into impact, were noted. This made it possible to separate the shells from the kernels without prior calibration of industrial hemp seeds. The research results demonstrated the advantages of the improved design, which includes an impeller with six profile holes, and the prospects of its use to increase the productivity of industrial hemp seed dehulling.
18 June 2026 in Technology audit and production reserves
The object of research is industrial hemp seeds of different batches and fractions, methods for assessing their physical, mechanical and technological properties. The problem is attributed to the insufficient level of methodology for assessing the properties of industrial hemp seeds (fractional composition, geometric, physical, mechanical and aerodynamic characteristics). The difference in the properties of four batches of industrial hemp seeds of different varietal and geographical origin is established by the set of main quality indicators and fractional structure. It is proposed to determine the patterns of changes in its technological indicators in the processes of cleaning, calibration and pneumatic separation based on the integral combination of the properties of individual fractions. The share of changes in the dominant average fraction is established within 54.18–70.35%. Significant heterogeneity of the fractional composition between batches of seeds is noted. Interdependent changes in the main linear dimensions of industrial hemp seeds are noted. The transition from coarse to fine fraction was accompanied by a consistent decrease in the width, length and thickness of the seeds. A change in the bulk density of the seeds of the batches was noted in the range from 445.3 to 537.3 g/l. The sliding angle and the static friction coefficient depended not only on the fraction, but also on the orientation of the seed on the surface. For the coarse fraction, the maximum sliding angle was 39.80°, and the maximum friction coefficient was 0.843 in the “root” position. An increase in the air velocity from the pseudo-fluidization mode to the complete removal of the sample was established. For the coarse fraction, the velocity was 5.20–12.22 m/s, for the medium fraction – 3.78–10.72 m/s, for the fine fraction – 2.92–10.15 m/s. The obtained patterns of changes in the properties of hemp seeds are advisable to use under the conditions of choosing the sizes of sieve openings, the angles of inclination of gravity surfaces, the parameters of bunkers and the operating speeds of the air flow.