13 August 2021 in Science
Constraining symmetry: Most superconductors have only one transition point, and below a certain temperature, their electrical resistance drops to zero. In very rare cases, another superconducting transition appears at a lower temperature. By measuring its specific heat, Hayes et al . reveal that this two-step superconductivity occurs in the compound uranium ditelluride. Complementary optical measurements indicated the breaking of time reversal symmetry, constraining the possible symmetries of the order parameter in this material. —JS
9 May 2024 in Nature Physics
24 August 2022 in Physical Review B
We study the temperature dependence of electrical resistivity for currents directed along all crystallographic axes of the spin-triplet superconductor . We focus particularly on an accurate determination of the resistivity along the axis () by using a generalized Montgomery technique that allows extraction of crystallographic resistivity components from a single sample. In contrast to expectations from the observed highly anisotropic band structure, our measurement of the absolute values of resistivities in all current directions reveals a surprisingly nearly isotropic transport behavior at temperatures above Kondo coherence, with , that evolves to reveal qualitatively distinct behaviors on cooling. The temperature dependence of exhibits a peak at a temperature much lower than the onset of Kondo coherence observed in and , consistent with features in magnetotransport and magnetization that point to a magnetic origin. A comparison to the temperature-dependent evolution of the scattering rate observed in angle-resolved photoemission spectroscopy experiments provides important insights into the underlying electronic structure necessary for building a microscopic model of superconductivity in .
4 September 2015 in Physical Review B
The recent conjecture of a topologically protected surface state in and the verification of robust surface conduction below 4 K have prompted a large effort to understand surface states. Conventional Hall transport measurements allow current to flow on all surfaces of a topological insulator, so such measurements are influenced by contributions from multiple surfaces of varying transport character. Instead, we study magnetotransport of using a Corbino geometry, which can directly measure the conductivity of a single, independent surface. Both (011) and (001) crystal surfaces show a strong negative magnetoresistance at all magnetic field angles measured. The (011) surface has a carrier mobility of with a carrier density of , which are significantly lower than indicated by Hall transport studies. This mobility value can explain the failure so far to observe Shubnikov–de Haas oscillations. Analysis of the angle dependence of conductivity on the (011) surface suggests a combination of a field-dependent enhancement of the carrier density and a suppression of Kondo scattering from native oxide layer magnetic moments as the likely origin of the negative magnetoresistance. Our results also reveal a hysteretic behavior whose magnitude depends on the magnetic field sweep rate and temperature. Although this feature becomes smaller when the field sweep is slower, it does not disappear or saturate during our slowest sweep-rate measurements, which is much slower than a typical magnetotransport trace. These observations cannot be explained by quantum interference corrections such as weak antilocalization but are more likely due to an extrinsic magnetic effect such as the magnetocaloric effect or glassy ordering.
10 June 2019 in Proceedings of the National Academy of Sciences
Significance: The realization of modern electrical and optoelectrical devices is possible because of the successful control of point defects in semiconductors or narrow band-gapped insulators. Recently, a new subclass of these semiconductors has been discovered, so-called topological insulators (TIs). These 3D TIs harbor a unique 2D conduction layer on the surfaces that can be potentially applicable for novel quantum devices. The access of these surface states, however, is easily hindered by bulk conduction from unintentional defects. Surprisingly, by using a unique resistance measurement in a strongly correlated TI , we find that typical defect signatures of a semiconductor in electrical transport are absent in the bulk, including samples prepared with large samarium-to-boron off-stoichiometry.
5 April 2018 in Physical Review Applied
We introduce a resistance measurement method that is useful in characterizing materials with both surface and bulk conduction, such as three-dimensional topological insulators. The transport geometry for this resistance measurement configuration consists of one current lead as a closed loop that fully encloses the other current lead on the surface, and two voltage leads that are both placed outside the loop. We show that, in the limit where the transport is dominated by the surface conductivity of the material, the four-terminal resistance measured from such a transport geometry is proportional to , where and are the bulk and surface conductivities of the material, respectively. We call this type of measurement inverted resistance measurement, as the resistance scales inversely with the bulk resistivity. We discuss possible implementations of this method by performing numerical calculations on different geometries and introduce strategies to extract the bulk and surface conductivities. We also demonstrate inverted resistance measurements on , a topological Kondo insulator, using both single-sided and coaxially aligned double-sided Corbino disk transport geometries. Using this method, we are able to measure the bulk conductivity, even at low temperatures, where the bulk conduction is much smaller than the surface conduction in this material.