10 June 2019 in Proceedings of the National Academy of Sciences
Significance: The realization of modern electrical and optoelectrical devices is possible because of the successful control of point defects in semiconductors or narrow band-gapped insulators. Recently, a new subclass of these semiconductors has been discovered, so-called topological insulators (TIs). These 3D TIs harbor a unique 2D conduction layer on the surfaces that can be potentially applicable for novel quantum devices. The access of these surface states, however, is easily hindered by bulk conduction from unintentional defects. Surprisingly, by using a unique resistance measurement in a strongly correlated TI , we find that typical defect signatures of a semiconductor in electrical transport are absent in the bulk, including samples prepared with large samarium-to-boron off-stoichiometry.
8 April 2020 in Physical Review B
After the theoretical prediction that is a topological Kondo insulator, there has been an explosion of studies on the surface. However, there is not yet an agreement on even the most basic quantities such as the surface carrier density and mobility. In this paper, we carefully revisit Corbino disk magnetotransport studies to find those surface transport parameters. We first show that subsurface cracks exist in the crystals, arising both from surface preparation and during the crystal growth. We provide evidence that these hidden subsurface cracks are additional conduction channels, and the large disagreement between earlier surface studies may originate from previous interpretations not taking this extra conduction path into account. We provide an update of more reliable magnetotransport data than the previous one (S. Wolgast et al., Phys. Rev. B 92, 115110) and find that the orders-of-magnitude large disagreements in carrier density and mobility come from the surface preparation and the transport geometry rather than the intrinsic sample quality. From this magnetotransport study, we find an updated estimate of the carrier density and mobility of (1/) and 104.5 (/), respectively. We compare our results with other studies of the surface. By this comparison, we provide insight into the disagreements and agreements of the previously reported angle-resolved photoemission spectroscopy, scanning tunneling microscopy, and magnetotorque quantum oscillations measurements.
22 April 2019 in Applied Physics Letters
Electron transport in N-polar GaN-based high-electron-mobility transistor (HEMT) structures with a combination of In0.18Al0.82N-AlN as the barrier was studied via temperature-dependent van der Pauw Hall and Shubnikov de Haas measurements. In contrast to Ga-polar HEMT structures, no persistent photoconductivity could be detected. In a sample with 10 nm thick InAlN, only one oscillation frequency was observed, demonstrating that a single sublevel is present. From the oscillations, a two-dimensional electron gas carrier density of 8.54 × 1012 cm−2 and a mobility of 4970 cm2/V s were extracted at 1.7 K. This sample was further investigated using ionic liquid gating. The charge density was varied from 7.5 × 1012 cm−2 to 9.6 × 1012 cm−2. The electron mobility significantly declined with decreasing charge density. This is in contrast to Ga-polar HEMT structures, where the electron mobility typically increases slightly as the charge density decreases.
7 May 2021 in Physical Review Materials
We investigate the roles of disorder on low-temperature transport in crystals grown by both the Al flux and floating zone methods. We used the inverted resistance method with Corbino geometry to investigate whether low-temperature variations in the standard resistance plateau arise from a surface or a bulk channel in floating zone samples. The results show significant sample-dependent residual bulk conduction, in contrast to smaller amounts of residual bulk conduction previously observed in Al flux grown samples with Sm vacancies. We consider hopping in an activated impurity band as a possible source for the observed bulk conduction, but it is unlikely that the large residual bulk conduction seen in floating zone samples is solely due to Sm vacancies. We therefore propose that one-dimensional defects, or dislocations, contribute as well. Using chemical etching, we find evidence for dislocations in both flux and floating zone samples, with higher dislocation density in floating zone samples than in Al flux grown samples. In addition to the possibility of transport through one-dimensional dislocations, we also discuss our results in the context of recent theoretical models of .
17 May 2017 in Physical Review B
We present a new model to explain the difference between the transport and spectroscopy gaps in samarium hexaboride (), which has been a mystery for some time. We propose that can be modeled as an intrinsic semiconductor with an accumulation length that diverges at cryogenic temperatures. In this model, we find a self-consistent solution to Poisson's equation in the bulk, with boundary conditions based on Fermi energy pinning due to surface charges. The solution yields band bending in the bulk; this explains the difference between the two gaps because spectroscopic methods measure the gap near the surface, while transport measures the average over the bulk. We also connect the model to transport parameters, including the Hall coefficient and thermopower, using semiclassical transport theory. The divergence of the accumulation length additionally explains the 10–12 K feature in data for these parameters, demonstrating a crossover from bulk dominated transport above this temperature to surface-dominated transport below this temperature. We find good agreement between our model and a collection of transport data from 4–40 K. This model can also be generalized to materials with similar band structure.
11 September 2019 in Journal of Superconductivity and Novel Magnetism