22 October 2018 in ACS Omega
An ultraviolet-enhanced (UV-enhanced) nitric oxide (NO) sensor based on silver-doped zinc oxide (ZnO) nanoflowers is developed using a low-cost hydrothermal method. The results indicate that silver (Ag) ions were doped into the ZnO nanostructure successfully, thus changing the morphology. In the high-resolution transmission electron microscopy images, we also found that some Ag ions were separated out onto the surface of the ZnO nanoflowers and that the Ag-doped and Ag nanoparticles improved the sensing property. The NO sensing property increased from 73.91 to 89.04% through the use of a UV light-emitting diode (UV-LED). The response time was approximately 120 s without the UV-LED, and the UV-enhanced Ag-doped ZnO nanoflower sensor exhibited a reduced response time (60 s). The best working temperature could be reduced from 200 to 150 °C using UV light illumination, and it was found that the NO response increased by 15.13% at 150 °C. The UV photoresponse of the Ag-doped ZnO nanoflowers and the mechanisms by which the improvement of NO sensing property occurred through the use of UV light illumination are discussed. The property of the gas sensor can be calibrated using a self-photoelectric effect under UV light illumination. These interesting UV-enhanced Ag-doped ZnO nanoflowers are viable candidates for practical applications.
15 November 2019 in ACS Omega
In this study, a flexible and stable pH sensor based on aluminum-doped zinc oxide nanosheets (Al-doped ZnO NSs) was developed by a low-cost hydrothermal method. The results obtained from this study indicated that Al ions could be doped successfully into the ZnO nanostructure, which could change the morphology and improve the pH-sensing properties. The pH sensitivity of Al-doped ZnO nanosheets reached 50.2 mV/pH with a correlation coefficient of around 0.99468 when compared with that of ZnO film (34.13 mV/pH) and pure ZnO nanowires (45.89 mV/pH). The test range of pH values was widened by Al-doping, and the Al-doped ZnO NS sensor could detect the pH value ranging from 2 to 12. It was observed that in a more acidic environment, especially at pH 2, the sensor, Al-doped ZnO nanosheet, was strongly stable over 12 weeks of testing. It was noted that the response time was utterly fast and the response time of the sensors for each pH standard buffer solutions was around 0.3 s. Thus, the response time and performance were quite stable. The microchannel provided a novel testing method for the pH sensor, where the liquid to be tested was just 5 mL. Hence, it was suggested to be useful for many medical diagnoses and treatments. The benefits of Al-doped ZnO nanosheet pH sensor were high sensitivity, good long-term usage, good flexible property, and requirement of a small amount of test liquid, which could make the sensors viable candidates for practical applications.
26 April 2018 in IEEE Sensors Journal
High-density porous zinc oxide (ZnO) nanosheets (NSs) are grown on an aluminum (Al) substrate, and a porous ZnO NS-based microelectromechanical systems technology gas sensor is fabricated for ozone (O3) detection. The height of this new ZnO nanostructure can be controlled by using different thicknesses of an Al seedlayer ranging from 25 to 100 nm. Additionally, the results indicate that an increase in the ozone response depends on oxygen vacancy adsorption, as measured by photoluminescence emission. This paper resulted in a low-temperature, hydrothermally grown novel porous ZnO NS ozone gas sensor that measured O3 responses of 96.1% at 300 °C and 53.4% at 150 °C. The response of this sensor compared with the responses of other semiconductor metal oxide materials is also very significant, with the porous ZnO NSs showing potential applications in gas sensing devices used for environmental monitoring.
6 May 2019 in IEEE Transactions on Device and Materials Reliability
Aluminum oxide-doped (Al2O3-doped) cactus-like ZnO nanoflowers with gold (Au) nanoparticles (NP) are grown on an aluminum (Al) substrate using a hydrothermal method to detect ethanol sensing in atmospheres with various degrees of relative humidity (RH). The microstructural measurement shows that the novel morphology cactus-like ZnO nanoflowers are approximately 3.5 5m high and Au NP are around 20 nm, highly dense and very uniform. The sensing performance is as high as 74.65% for 10 ppm ethanol and 42.09% for a low concentration of 2 ppm at 2000C. A comparison of ethanol detection properties in atmospheres with various degrees of relative humidity shows that the response of cactus-like ZnO nanoflowers to 10 ppm ethanol decreases from 55.27% at 25% RH to 47.64% at 85% RH. The response of traditional pure ZnO nanowires decreases from 44.65% to 4.98 at 25% to 85% RH. The cactus-like ZnO nanoflowers having better resistance to moisture. The novel cactus-like ZnO nanoflowers are sufficiently sensitive to ethanol in an atmosphere with high humidity to allow effective and accurate analysis of the amount of alcohol in breath.