The paper presents the results of studies of microstructure, mechanical and physicochemical properties of surface layers produced by laser modification of the diffusion boron layer on Monel® Alloy 400. The diffusion boron layers were produced at 950 °C for 6 h. The gas-contact method was used in an open retort furnace. The process was carried out in a powder mixture containing B4C carbide as a boron source. The next stage was the modification of the boron layer with a diode laser beam of a nominal power of 3 kW. A constant power of 1400 W of the laser beam was used. The scanning speed was variable (successively 5 m/min, 25 m/min, 50 m/min). In order to determine the best parameters, single tracks were created, after which multiple tracks were prepared using previously selected parameters. It was found that both the diffusion borided layer and the laser modified layer had better properties than the substrate material. Both these processes contributed to an increase in corrosion resistance, hardness and wear resistance. It was also found that laser modification caused a slight deterioration of the properties in comparison with the diffusion borided layer. However, the laser modification process resulted in the production of a much thicker layer.
Nimonic 80A-alloy belongs to Nickel-based superalloys. Many of them are used in variety branches of industry due to high strength and resistance in aggressive conditions. Moreover, its mechanical properties are kept in high temperature. However, these materials should be coated by appropriate wear protection, under conditions of considerable mechanical wear. Unfortunately, the production of thick borided layer in diffusion boriding required high temperature and long duration of this processes. Therefore, in this study instead conventional diffusion process laser boriding was applied in order to produce boride layer on Nimonic 80A-alloy substrate. Laser alloying is the high-tech process which allows to modify the chemical composition of the surface. Laser boriding was arranged as a single tracks, therefore it was possible to evaluate the influence of laser treatment parameters on thickness and hardness of produced layers. The laser beam power P, laser scanning speed vl and laser beam diameter dl were the variable parameters used during laser alloying.
This paper presents the results of the microstructure, mechanical and physicochemical properties of coatings produced by the remelting of a VC pre-coat applied in the form of a paste on 145Cr6 steel. The remelting process was carried out using a diode laser beam. A laser device with a rated power of 3 kW was used. During these tests, a constant laser beam scanning speed of 3 m/min was used. The variable parameter was the laser beam power. Values of 500 W, 900 W and 1100 W were used. In the first stage of this study, single laser tracks were formed, and basic tests, such as on microstructure, microhardness and chemical composition, were performed. In the second stage of this study, multiple laser tracks were prepared using previously selected parameters. On such specimens, it was possible to test the same traits as for single tracks and, additionally, to perform corrosion and wear resistance tests. It was found that the obtained coatings have different properties than the base material. No primary vanadium carbides were found in the melted zone, but the proposed production method contributed to an increase in microhardness and wear resistance.
1 December 2022 in Advances in Science and Technology Research Journal
The paper concerns the monitoring of the tool condition on the basis of vibration acceleration signals. The cutting edge condition is determined by wear on the flank surface of the drill. As tools, a twist drills made of cemented carbide were used. A gray cast iron plate EN-GJL-250 was used as...