19 August 2020 in Classical and Quantum Gravity
The TianQin-1 satellite (TQ-1), which is the first technology demonstration satellite for the TianQin project, was launched on 20 December 2019. The first round of experiment had been carried out from 21 December 2019 until 1 April 2020. The residual acceleration of the satellite is found to be about 1 × 10 −10 m/s 2 /Hz 1/2 at 0.1 Hz and about 5 × 10 −11 m/s 2 /Hz 1/2 at 0.05 Hz, measured by an inertial sensor with a sensitivity of 5 × 10 −12 m/s 2 /Hz 1/2 at 0.1 Hz. The micro-Newton thrusters has demonstrated a thrust resolution of 0.1 μ N and a thrust noise of 0.3 μ N/Hz 1/2 at 0.1 Hz. The residual noise of the satellite with drag-free control is 3 × 10 −9 m/s 2 /Hz 1/2 at 0.1 Hz. The noise level of the optical readout system is about 30 pm/Hz 1/2 at 0.1 Hz. The temperature stability at temperature monitoring position is controlled to be about ±3 mK per orbit, and the mismatch between the center-of-mass of the satellite and that of the test mass is measured with a precision of better than 0.1 mm.
19 August 2025 in Classical and Quantum Gravity
TianQin is a future space-based gravitational wave (GW) observatory targeting the frequency window of 10−4–1 Hz. A large variety of GW sources are expected in this frequency band, including the merger of massive black hole binaries, the inspiral of extreme/intermediate mass ratio systems, stellar-mass black hole binaries, Galactic compact binaries, and so on. TianQin will consist of three Earth orbiting satellites on nearly identical orbits with orbital radii of about 105 km. The satellites will form a normal triangle constellation whose plane is nearly perpendicular to the ecliptic plane. The TianQin project has been progressing smoothly following the ‘0123’ technology roadmap. In step ‘0’, the TianQin laser ranging station has been constructed and it has successfully ranged to all the five retro-reflectors on the Moon. In step ‘1’, the drag-free control technology has been tested and demonstrated using the TianQin-1 satellite. In step ‘2’, the inter-satellite laser interferometry technology will be tested using the pair of TianQin-2 satellites. The TianQin-2 mission has been officially approved and the satellites will be launched around 2026. In step ‘3’, i.e. the TianQin-3 mission, three identical satellites will be launched around 2035 to form the space-based GW detector, TianQin, and to start GW detection in space.
4 May 2020 in Classical and Quantum Gravity
TianQin is a Chinese space-based observatory concept with three drag-free spacecraft orbiting the earth to observe gravitational-waves in the millihertz range. Electrical charge is inevitably accumulating on its isolated test masses which are used as the mirrors for interferometers to measure gravity variation. Charge management system based on ultraviolet (UV) light is developed to reduce the charge-induced noises acting on the test mass in space gravitational experiments such as GP-B, LISA, LISA Pathfinder and TianQin mission. The UV LED is a new UV light source with some advantages relative to mercury lamps, such as smaller size, lighter weight, lower power consumption and higher efficiency. For these reasons, ground-based tests for the combination of UV LED and inertial sensor are essential. This paper presents the development of a charge management system based on a UV LED, its application to a torsion pendulum system with a TianQin-like test mass, and assesses the charge-management performance of the system. The experimental results indicate that the isolated test mass can be charged positively or negatively through UV illumination. It demonstrates that the charging and discharging rates can both reach higher than 10 5 e s −1 , as well as spectral measurement of the pendulum charge resulting in a white noise level equivalent to ∼5 × 10 5 e Hz − 1/2 , satisfying the TianQin requirement.
5 July 2022 in Classical and Quantum Gravity
Drag-free control (DFC) is one of the key technologies for space-borne gravitational wave detectors. For the TianQin (TQ) project, non-gravitational disturbances on the spacecraft must be suppressed by DFC. TianQin-1 (TQ-1) is the first satellite for technology verification, whose main goal is to verify the disturbances reduction technologies. In this paper, the DFC requirement and preliminary analysis for the TQ project are introduced, and then the design and the experimental validation with the TQ-1 satellite is presented. In-orbit results show a successful validation of DFC and the residual acceleration of TQ-1 satellite has been suppressed to at 10 mHz versus thruster noise.
3 April 2023 in Physical Review Applied
The squeeze-film-damping effect is one of the main limits in many precision experiments, especially in the study of short-range interactions, and its physical mechanism is still not very clear. We develop a torsion pendulum to measure the damping effects caused by the thermal motion of residual gas between a cubic test mass and a pair of symmetric movable plates. The measured results are consistent with the model that synthesized the elastic and inelastic collisions by introducing a thermal accommodation coefficient (TAC). In our research, the pressure dependence of the TAC, which can be expressed as an exponential decay function, is also observed. This dependence may imply that the elastic collisions correspond to the simple bouncing of residual gas molecules, while the inelastic collisions correspond to the adsorption and desorption cycle of gas molecules on the surface. The method in this work and the discovered TAC pressure dependence are instructive for the analysis of residual-gas effects in weak-force measurements, as well as the deviation correction of rarefied gas pressure measurements based on the squeeze-film-damping effect.