Biomaterial scaffolds house and direct cells to grow, exposing them to appropriate growth factors. Most of them are designed to degrade at a controlled rate as the new host tissue replaces them. Here, we show that scaffolds obtained through electrospinning of PVA with 3.5, 4.0, and 5.0 wt% of SA showed a gradual degradation rate under physiological conditions during 100 days of incubation. This behavior is proportional to the SA concentration used, with a mass loss of (41%, 47%, and 49% for each system) after 60 days. Moreover, the dielectric properties (EIS) of the scaffolds correlate with their degradation rate throughout the exposition period (100 days), as indicated by the observed decrease in resistance over time. The 4.0 wt% system showed the lowest capacitance value (1.5 10–5 F) and the highest resistance (4.6106 ohm‐cm2) behavior among all concentrations. Additionally, the morphological analysis through SEM and AFM showed a shrank in the surface morphology after the degradation process and determined the degree of roughness (Ra). Higher roughness prior to the cytocompatibility test promoted increased proliferation and adhesion of HaCat cells, as observed in the 4.0 wt% PVA/SA system (1422 nm Ra). These biomaterials have great potential in wound dressing applications.
The bronze patina is aesthetically pleasing and enhances the corrosion resistance of the metallic object. This corrosion product layer can develop naturally, through aging or artificially. However, artificial methods require substances that are hazardous to human health and the environment. In this study, a sustainable approach to patina development, based on the anodic polarization of a 85.5Cu-4.2Pb-4.5Sn-5.7Zn copper alloy immersed in 0.1 M NaCl + 0.01 M NaHCO3 were characterized using polarization curves, chronoamperometry, electrochemical impedance spectroscopy, electrochemical noise measurements, X-ray diffraction, and scanning electron microscopy. The results indicate that the anodic potential modifies the current density as well as the diffusion coefficient of oxygen associated with a thicker corrosion product layer. Electrochemical Impedance spectroscopy and electrochemical noise show that the porous behaviour and corrosion resistance increases as the potential becomes more anodic due to the formation of a protective layer. This behaviour corresponded with the results acquired by chronoamperometry. The surface characterization shows that the potential applied changes the surface morphology and composition of the corrosion products, being identified the crystalline phases of nantokite and atacamite although Cu, Cl, O, Zn, and Pb elements were also detected.
25 February 2016 in Surface and Interface Analysis