Temperature, voltage, and current sensors monitor the operation of a TCP/IP offload accelerator engine fabricated in 90nm CMOS, and a control unit dynamically changes frequency, voltage, and body bias for optimum performance and energy efficiency. Fast response to droops and temperature changes is enabled by a multi-PLL clocking unit and on-chip body bias. Adaptive techniques are also used to compensate performance degradation due to device aging, reducing the aging guardband.
19 February 2014 in IEEE Journal of Solid-State Circuits
A fully integrated switched capacitor voltage regulator (SCVR) with on-die high density MIM capacitor, distributed across a 14 KB register file (RF) load is demonstrated in 22 nm tri-gate CMOS. The multi-conversion-ratio SCVR provides a wide output voltage range of 0.45-1 V from a fixed input voltage of 1.225 V. It achieves 63-84% conversion efficiency and supports a maximum load current density of 0.88 A/mm2. The area overhead of the dedicated SCVR on the load is 3.6%. Measured data is presented on various performance indices in detail. Subsequent learning on tradeoffs between various factors like capacitance characteristics, conversion efficiency and current density are delineated and, correlated with theoretical estimates. Performance of RF array shows comparable results when powered with the SCVR and the external rail. The all-digital, modular design allows efficient spatial distribution across the load and hence robust power delivery. The extremely fast response times in the order of few nanoseconds is targeted to benefit agile power management. This work evinces voltage regulator technology as a standard homogenous CMOS component, which can proliferate DVFS domains for maximum energy and area benefits.
6 December 2017 in IEEE Journal of Solid-State Circuits
A fully integrated digitally controlled buck voltage regulator, featuring hysteretic and pulse frequency modulation control for maximum light load efficiency, with 3-D through-silicon-via-based on-die solenoid inductor with a planar magnetic core in 14-nm tri-gate CMOS, demonstrates 111 nH/mm² inductance density and 80% conversion efficiency. The inductance density demonstrated is 20x higher than comparable on-die lateral- or spiral-based inductor densities leading to higher light load efficiency.
25 October 2017 in IEEE Journal of Solid-State Circuits
A fully integrated digitally controlled two-phase buck voltage regulator (VR) with on-die solenoid inductors with a planar magnetic core is demonstrated in 14-nm tri-gate CMOS for fine-grained power delivery/management domains of high power density in system-on-chips while enabling ultra-thin (z-height) packages. The VR achieves 1-A/mm² power density for 400-mA load current with a measured peak efficiency of 84% at 100-MHz switching frequency including a digital PWM with >9 bits (8 ps) of resolution.
9 January 2020 in IEEE Journal of Solid-State Circuits
Fully integrated voltage regulators (FIVRs) offer many advantages, such as fine-grained power management, fast transient response, and reduced form factor. This article addresses light-load efficiency in FIVRs with nH-scale air-core inductors. The challenges of implementing efficient discontinuous conduction mode (DCM) operation at high switching frequencies are discussed, which include zero current detection, inductor ac-loss effects, and power delivery network (PDN) resonances. A prototype in 14-nm CMOS is presented, which shows the DCM operation at up to 70 MHz with a peak efficiency of 88% for 1.6-1.2-V conversion.