A fully integrated digitally controlled buck voltage regulator, featuring hysteretic and pulse frequency modulation control for maximum light load efficiency, with 3-D through-silicon-via-based on-die solenoid inductor with a planar magnetic core in 14-nm tri-gate CMOS, demonstrates 111 nH/mm² inductance density and 80% conversion efficiency. The inductance density demonstrated is 20x higher than comparable on-die lateral- or spiral-based inductor densities leading to higher light load efficiency.
25 October 2017 in IEEE Journal of Solid-State Circuits
A fully integrated digitally controlled two-phase buck voltage regulator (VR) with on-die solenoid inductors with a planar magnetic core is demonstrated in 14-nm tri-gate CMOS for fine-grained power delivery/management domains of high power density in system-on-chips while enabling ultra-thin (z-height) packages. The VR achieves 1-A/mm² power density for 400-mA load current with a measured peak efficiency of 84% at 100-MHz switching frequency including a digital PWM with >9 bits (8 ps) of resolution.
9 January 2020 in IEEE Journal of Solid-State Circuits
Fully integrated voltage regulators (FIVRs) offer many advantages, such as fine-grained power management, fast transient response, and reduced form factor. This article addresses light-load efficiency in FIVRs with nH-scale air-core inductors. The challenges of implementing efficient discontinuous conduction mode (DCM) operation at high switching frequencies are discussed, which include zero current detection, inductor ac-loss effects, and power delivery network (PDN) resonances. A prototype in 14-nm CMOS is presented, which shows the DCM operation at up to 70 MHz with a peak efficiency of 88% for 1.6-1.2-V conversion.
28 January 2022 in IEEE Journal of Solid-State Circuits
A buck converter using a low-voltage GaN nMOS power transistor with 5– $10\times $ superior switching figure-of-merit over Si laterally-diffused MOS (LDMOS) and stacked CMOS at 5 V has been employed to build a high-frequency (3–20 MHz), high-density (9 A/mm 2 ) buck converter for high-performance-compute applications. The GaN-based converter is co-packaged with a CMOS Companion Die on a 4 mm $\times $ 4 mm package and employs on-die gate clamps to minimize the impact of package parasitics for high efficiency. For 5-V input to 1-V output conversion, the converter achieves 94.2% peak efficiency at 3.1-MHz switching frequency with a 40-nH inductor, and >80% peak efficiency at 20 MHz with an air-core inductor.
28 January 2021 in IEEE Journal of Solid-State Circuits
A side-channel attack (SCA) hardened AES-128 and RSA crypto-processor in 14-nm CMOS with measured resistance to correlation power/electromagnetic analysis (CPA/CEMA) in both time and frequency domains is demonstrated. While previously reported linear low-dropout regulators (LDOs) offer improvements in minimum-time-to-disclose (MTD) of extracted key bytes in the time domain, their transformations are less effective against frequency-domain attacks. This article describes a non-linear digital LDO (NL-DLDO) with control loop randomizations that bolster SCA resistance in the frequency domain. The NL-DLDO cascaded with an AES engine augmented with arithmetic countermeasures enables >250Kx improvement in MTD, with no CPA/CEMA/DNN attacks detected after 1-B encryptions, with 8% power and 10% area overheads incurred by arithmetic techniques. The RSA-4K crypto-processor implements exponent magnitude and timing randomizations along with dynamic memory addressing to mitigate time- and frequency-domain attacks. The countermeasures enable 711x suppression in means separation in current/EM magnitudes from 3.1 mV to 4.35 μV, reducing attacker's accuracy to an ineffective random guess classification, while limiting area and performance overheads to <0.05% and 3.25%, respectively.