Objective: Retrospective study of the functional outcome of patients with lumbar disc herniation who underwent full-endoscopic discectomy. Methods: Fifteen consecutive patients, 10 men and 5 women, mean age of 34.2 years, were evaluated at 15, 30, 90 and 180 days after surgery through the Oswestry Disability Index (ODI) questionnaire and the Visual Analogue Scale (VAS) of axial and lower limbs pain. Results: There was a significant improvement in ODI evaluation of patients when comparing the preoperative results with the third and sixth postoperative month (p<0.05), as well as the VAS for preoperative axial pain with respect to 15, 30 and 90 days (p<0.05) after surgery, and VAS for preoperative pain in the lower limbs with respect to 15, 90 and 180 days postoperatively (p<0.05). Conclusion: The full-endoscopic discectomy is an effective procedure which should be considered as an alternative to conventional discectomy.
Introduction: This study aims to evaluate the safety of using the cortical path screw with transfixation of the second cortical bone in relation to the vascular structures. Methods: This retrospective observational study (level of evidence: III, study of non-consecutive patients) analyzed data from the medical records of patients who underwent computed angiotomography scans of the abdomen at Hospital Mater Dei, measuring, in millimeters, the distance between the point of the lumbar vertebra considered the anatomical reference for the transfixation of the second cortical bone and the vascular structures adjacent to the spine (abdominal aorta, inferior vena cava, iliac vessels, segmental lumbar arteries). Results: Forty-eight patients were evaluated, with a mean age of 60 years (±8 years, 41-75), of whom 52% were male and 48% female. The measurements obtained between the pre-vertebral vessels and the possible screw exit points did not demonstrate contact in any of the vertebrae studied. Conclusions: The measurements obtained suggest the safety of using the cortical path screw transfixing the second cortical bone. Knowing the position of the vessels is essential to reduce intra- and postoperative complications related to spinal instrumentation. Level of evidence III; Study of non-consecutive patients.
Objective: To evaluate the interobserver agreement of the new AOSpine classification for subaxial cervical fractures. Methods: A descriptive study, which11 traumatic lesions of the subaxial cervical spine (through radiographic and tomographic images), were evaluated by 16 observers being: 6 senior surgeons, 4 fellows in spinal surgery and 6 physicians residents in Orthopedics and Traumatology by the new AOSpine classification, with subsequent statistical analysis of the results. An agreement analysis was performed using the Kappa coefficient, both individually and in combination, with an interpretation of the index performed using the standardized model for Landis and Koch. To determine the level of significance of the analyzes, values less than 0.05 were considered statistically significant. Results: In general, the level of agreement among the examiners was considered reasonable. The lesions “A0 (F3)”, “A4 (F3)”, “B1”, “B3”, “B3 (F3)”, “C”, “C (F3)” and “F3”showed a low level of agreement between the examiners. The level of reasonable agreement was obtained between fractures “A0”, “A1”, “A4”, “B2” and “C (F4)”. The only fracture that presented a moderate level of agreement was the “C (F4 BL)” lesion. This result indicates that the referred injury was the fracture of the subaxial column that presented the best level of agreement among the 16 examiners in the present study. Conclusions: The results of the study indicate an intermediate agreement of the new AOSpine classification for subaxial cervical lesion and point to the need to carry out studies that seek to evaluate this new classification in order to better evaluate its strengths and weaknesses, contributing for its improvement. Level of evidence III; Diagnostic study - investigation of a diagnostic test.
Objective To evaluate the immediate correction capacity of the Wood-Chêneau-Rigo brace (WCR), produced using digital technological resources and robotic engineering, in primary and secondary curves of adolescent idiopathic scoliosis (AIS). Methods A retrospective study was conducted of 138 patients with a diagnosis of AIS and who received a WCR brace from a laboratory that makes orthoses and orthopedic prostheses between 2019 and 2021. These individuals were submitted to an independent analysis of the radiographic parameters by a single researcher, the main outcome of which was the standardized measurement of the main and secondary curves using the Cobb method. The radiographs analyzed were performed in orthostasis before and immediately after the adaptation of the brace on the patient. The correction capacity was calculated as the ratio of the difference between the pre- and post-brace curves to the pre-brace curve. Results The mean correction with the WCR was 48.4% for the main curve and 41.0% for the secondary curve. The level of correction of the main curve was significantly higher in patients with a main curve with the apex of convexity in the thoracolumbar region (p = 0.004), especially in the left thoracolumbar region (p = 0.010); curves of magnitude between 10º and 24.9º (p <0.001); and curves classified as simple (p <0.001). Conclusion The use of the WCR, which is produced using modern technological resources, was effective in the immediate correction of AIS. Long-term studies on this new modality of conservative scoliosis treatment are necessary. Level of evidence III; Retrospective study.
Introduction: This study aimed to evaluate the mechanical resistance to pullout of the lumbar cortical bone trajectory (CBT) screw with and without transfixation of the second cortical in a biomechanical assay in swine vertebrae. Methods: A pullout test was performed in 16 swine vertebrae (L5 and L6) fixed with 32 CBT screws using the same protocol. Of these, 16 were inserted in a monocortical manner according to the original technique and 16 through a modified technique which included the transfixation of the second cortical bone. Results: The average maximum load value for pulling out the inserted screws with the modified technique including the transfixation of the second cortical bone was 140.50 Kgf (± 56.56), while in the original technique it was 95.69 Kgf (± 42.19) (p = 0.004). Conclusion: The biomechanical tests applied to the studied sample showed that the pullout resistance of the CBT screws inserted with the bicortical technique was, on average, 46% higher than the screws inserted according to the original monocortical technique. Level of Evidence II; Experimental study.
Objective Morphometric study of the positioning of the cortical trajectory pedicle screw in the lumbar spine of Brazilian patients of different sexes and ages, through the use of computed tomography images, in order to obtain more reliable data about cortical screw insertion and the variations observed, providing assistance for a safer, more effective approach with fewer complications. Methods Selection of 100 patients from a database, alternating by sex, measuring the length, diameter, cephalic angulation, and lateral angulation of the vertebrae from L1 to L5. Results Statistically significant measurements were obtained for the four different parameters in relation to sex. The mean age was 56, with a minimum of 20 and a maximum of 87 years. The L4 and L5 screws showed a reduction in relation to the other levels, while the width showed a progressive increase starting at L3. Lateral angulation was the parameter with the least variation among the levels, while there was greater variation and a reduction from L4 to L5 in cephalic angulation. Conclusion Statistically significant results were obtained for length, diameter, lateral and cephalic angulation. Sex was a significant factor in spine surgery instrumentation using the cortical trajectory pedicle screw technique. Level of evidence I; Diagnostic study (investigation of an examination for diagnosis).