Jianxin Geng

Jianxin Geng

Auto-generated profile, based on publicly available information

Jianxin Geng

State Key Laboratory of Advanced Separation Membrane Materials Tianjin Key Laboratory of Advanced Fibers and Energy Storage School of Material Science and Engineering Tiangong University No. 399 BinShuiXi Road XiQing District Tianjin 300387 China

Research Focus & Metrics

Academic Career Length

26Years (2001-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2016 in Nature Communications
Verified
Journal Article
Open access
GLGuoxing Li
Guoxing Li
JSJinhua Sun
Jinhua Sun
WHWenpeng Hou
Wenpeng Hou
SJShidong Jiang
Shidong Jiang
YHYong Huang
Yong Huang
JGJianxin Geng
Jianxin Geng
Sulfur is a promising cathode material for lithium–sulfur batteries because of its high theoretical capacity (1,675 mA h g−1); however, its low electrical conductivity and the instability of sulfur-based electrodes limit its practical application. Here we report a facile in situ method for preparing three-dimensional porous graphitic carbon composites containing sulfur nanoparticles (3D S@PGC). With this strategy, the sulfur content of the composites can be tuned to a high level (up to 90 wt%). Because of the high sulfur content, the nanoscale distribution of the sulfur particles, and the covalent bonding between the sulfur and the PGC, the developed 3D S@PGC cathodes exhibit excellent performance, with a high sulfur utilization, high specific capacity (1,382, 1,242 and 1,115 mA h g−1 at 0.5, 1 and 2 C, respectively), long cycling life (small capacity decay of 0.039% per cycle over 1,000 cycles at 2 C) and excellent rate capability at a high charge/discharge current.

26 February 2009 in Chemical Communications
Verified
Journal Article
Closed access
PDF file
BKByung-Seon Kong
Byung-Seon Kong
JGJianxin Geng
Jianxin Geng
Hee-Tae JungHee-Tae Jung
Hee-Tae Jung
Layer-by-layer films comprised of alternating graphene and gold nanoparticle layers are readily produced by the two-step procedure involving the use of vacuum filtration of a reduced graphene oxide solution to fabricate the graphene thin film on the quartz substrate, followed by gold nanoparticle formation by spontaneous reduction of gold ions in a gold salt solution on the graphene films.


12 September 2011 in Organic & Biomolecular Chemistry
Verified
Journal Article
Closed access
PDF file
DDDaniel R. Dreyer
Daniel R. Dreyer
HJHong-Peng Jia
Hong-Peng Jia
ATAlexander D. Todd
Alexander D. Todd
JGJianxin Geng
Jianxin Geng
Christopher BielawskiChristopher Bielawski
Christopher Bielawski
The selective oxidation of thiols to disulfides and sulfides to sulfoxides using graphite oxide (GO), a heterogeneous carbocatalyst obtained from low cost, commercial starting materials is described. The aforementioned oxidation reactions were found to proceed rapidly (as short as 10 min in some cases) and in good yield (51–100%) (19 examples). No over-oxidation of the substrates was observed, and GO's heterogeneous nature facilitated isolation and purification of the target products.

1 December 2006 in Journal of the American Chemical Society
Verified
Journal Article
Closed access
JGJianxin Geng
Jianxin Geng
TZTingying Zeng
Tingying Zeng

1 October 2013 in Carbon
Verified
Journal Article
Closed access
WOWenzhu Ouyang
Wenzhu Ouyang
JSJinhua Sun
Jinhua Sun
JMJamil Memon
Jamil Memon
CWChao Wang
Chao Wang
JGJianxin Geng
Jianxin Geng
YHYong Huang
Yong Huang