The use of agricultural residue has been considered an economic and environmentally friendly approach for development of aluminium composites. In this study, Al powder (Al) was reinforced with coconut shell ash (CSA), rice husk ash (RHA), and cassava peel ash (CPA) for enhanced physicomechanical performance of the resulting composites. Five samples (Ao–Al, A1–Al + 15RHA, A2–Al + 5CSA + 5RHA + 5CPA, A3–Al + 15CPA, and A4–Al + 15RHA) were prepared in a two-step stir-casting technique and characterized based on physical, mechanical and metallurgical properties. Microstructural analysis revealed that all the particles bonded well with the aluminum alloy. The densities of samples A1, A2, A3, and A4 reduced by 4.78%, 7.75%, 11.44%, and 14.76%, respectively compared to the control sample Ao while porosities rose by 2.1%, 2.23%, 2.56%, and 2.98% respectively. Sample A2 has the highest tensile strength (39.84 MPa) and hardness (120 HBR) which denote 33.60% and 64.27% enhancement compared to the unreinforced sample. These observations can be attributed to the presence of intermetallic compounds such as Fe3Si and Al6Fe present in the composites as well as uniformly distributed and strongly bounded reinforcement within the aluminum matrix. The composite made from the combination of the three reinforcements gave the best physicomechanical properties and therefore recommended for engineering applications.
High-quality nanostructure of dysprosium substituted nickel–cobalt ferrite and their composite with reduced graphene oxide (rGO) were synthesized. The structuraland photocatalytic properties of prepared samples were studied. The XRD and FTIR analysis confirmed the FCC spinel structure. The calculated average crystallite size of nanoparticles was around 7.8 nm. The bandgap energy of synthesized composition was found to be 2.27 eV. The uniform dispersion of nanoparticles on the graphene nanosheets were confirmed by the FESEM analysis. The photocatalytic efficiency of nanoparticles and their composites with rGO was studied for degradation of methylene blue (MB) under visible light irradiation. It was found that nanocomposite exhibited high photocatalytic activity (72.7%) as compared to Dy+3 substituted Ni-Co ferrite nanoparticles (52.4%). This enhanced photocatalytic activity can be attributed to the presence of graphene, which enhances the stability of nanocomposite and reduces the recombination of charge carriers.
1 January 2021 in Journal of Taibah University for Science
A new composite oxide (NiO/SnO2) photocatalyst was synthesized by simple co-precipitation route. The structural elucidation of composite oxide photocatalyst was carried out via X-rays diffraction (XRD) technique. The morphology was determined by scanning electron microscopy (SEM). The Fourier transform infra-red (FTIR) and UV–visible spectroscopic techniques revealed the spectral and optical features. XRD analysis confirmed the formation of binary metal oxide nanocomposite comprising NiO in cubic and SnO2 in the tetragonal crystalline phase. The crystallite size for NiO/SnO2 calculated from XRD was < 15 nm. The spectroscopic studies also supported the XRD data. The morphological study of NiO/SnO2 revealed the formation of relatively small rounded nanoparticles. The solar light driven photocatalytic degradation study showed about 54% degradation of methylene blue and 34% degradation of Congo red and the value of rate constant for NiO/SnO2 was found to be 0.0059 min−1. The mechanism of degradation of dyes was also explored and discussed.
26 April 2022 in Journal of Taibah University for Science
The co-precipitation route was used for the preparation of Nd-substituted NiFe2O4. The proposed general formula of prepared ferrite was NdxNiFe2-xO4. Here, “x” the moles of Nd3+ were 0.0, 0.0125, 0.025 and 0.05 in various compositions. The prepared nanocrystallites were characterized using X-rays diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), vibrating sample magnetometer (VSM) and impedance analyzer. XRD patterns of all prepared samples were analyzed to confirm the phase of the materials and determine the lattice constant, crystallite size and X-rays density. The lattice parameter value varied between 8.3501 and 8.3549 Å. The average crystallite size was ∼15 nm. The FTIR spectral analysis was used to investigate the M-O stretching vibrational bands. FTIR spectra showed the stretching vibrational bands of Fe-O at octahedral and tetrahedral sites. After structural and spectral investigations, the prepared nanocrystallites were subjected to room temperature magnetic measurements by vibrating sample magnetometry (VSM) technique. The magnetic parameters were investigated from the VSM data. The magnetic parameters suggested the possible utilization of these nanocrystalline ferrites for various advanced technological applications like switching devices and high-frequency devices. The dielectric parameters were also investigated using an impedance analyzer.
1 January 2021 in Journal of Taibah University for Science
Photocatalytic ability of Lithium-Cobalt ferrites was improved by doping with Bi. For the synthesis of different compositions of Bi-doped Li-Co Ferrites, the Micro-Emulsion method was used. X-ray diffraction (XRD) and Fourier transform infrared (FTIR) and Scanning Electron Microscopy (SEM) analyses confirmed its spinel structure and morphology. Bi-substituted Li-Co ferrites exhibit 93.8% and 83.9% degradation of methylene blue and crystal violet, respectively. While using scavenger this value of degradation of crystal violet exceeds up to 98.5%. The rate constants of LiCo0.5Bi0.4Fe1.6O4 for methylene blue (MB) and crystal violet (CV) are 0.0203 and 0.01615 min−1, respectively. The band gap energy value calculated using tauc plot is 2.70 eV and 3.95Ev for Li-Co ferrites and Bi-doped Li-Co ferrites, respectively. Electrochemical impedance spectroscopy (EIS) studies confirmed that the doping of Bi in Li-Co spinel ferrites enhances its conductance. The use of these ferrites for photocatalytic degradation is more beneficial because they can be easily separable afterwards due to their magnetic nature which is confirmed by studying the re-usability of the as-synthesized samples. Highlights GRAPHICAL ABSTRACT