The use of agricultural residue has been considered an economic and environmentally friendly approach for development of aluminium composites. In this study, Al powder (Al) was reinforced with coconut shell ash (CSA), rice husk ash (RHA), and cassava peel ash (CPA) for enhanced physicomechanical performance of the resulting composites. Five samples (Ao–Al, A1–Al + 15RHA, A2–Al + 5CSA + 5RHA + 5CPA, A3–Al + 15CPA, and A4–Al + 15RHA) were prepared in a two-step stir-casting technique and characterized based on physical, mechanical and metallurgical properties. Microstructural analysis revealed that all the particles bonded well with the aluminum alloy. The densities of samples A1, A2, A3, and A4 reduced by 4.78%, 7.75%, 11.44%, and 14.76%, respectively compared to the control sample Ao while porosities rose by 2.1%, 2.23%, 2.56%, and 2.98% respectively. Sample A2 has the highest tensile strength (39.84 MPa) and hardness (120 HBR) which denote 33.60% and 64.27% enhancement compared to the unreinforced sample. These observations can be attributed to the presence of intermetallic compounds such as Fe3Si and Al6Fe present in the composites as well as uniformly distributed and strongly bounded reinforcement within the aluminum matrix. The composite made from the combination of the three reinforcements gave the best physicomechanical properties and therefore recommended for engineering applications.
Aluminium metal matrix composites have gained a lot of attention because of their outstanding properties making them useful for aerospace, automobile and marine applications. Composites are replacing metals as structural materials, and a detailed study of the relationship between hardness and Young’s modulus becomes essential. In this paper, the correlation between hardness and elastic modulus of discarded aluminum pistons reinforced with zirconium diboride and snail shells is presented. The theoretical hardness was determined from the ratio of indentation hardness to indentation modulus while elastic modulus was evaluated based on composite equation. The results indicated that hardness and elastic modulus increased with the weight percentage of the composites while the resistance to plastic deformation H3/E2 increased with H. The wide discrepancy between the theoretical and experimental Young’s modulus is attributed to the fact that theoretical elastic moduli were obtained from perfect/single crystal materials while experimental values are obtained from polycrystalline/imperfect crystals. The calculated Young’s moduli obtained through mixture rule range from 64 to 92 GPa which are higher than 69 GPa of aluminium alloy. It is therefore evident that the composite materials can be used for engineering applications.