1 February 2019 in Journal of Materials in Civil Engineering
The disposal of fly ash is an environmental challenge globally, and the only viable solution for its mass disposal is its use in the construction industry, especially for brick production. Hence, the substantial growth in masonry structures using fly ash bricks in India where coal-based power plants dominate the power sector has been recently seen. However, the safety and strength assessment of structures made of fly ash bricks often require the modeling of the uncertainty of its properties. The present study investigated the variability of compressive strength of fly ash bricks and proposes the most appropriate model for the statistical distribution. Twenty-six probability distributions were considered to conduct the three goodness-of-fit tests, namely, Kolmogorov-Smirnov, Kolmogorov-Smirnov-Lilliefors, and Anderson-Darling tests. The analysis concluded that the Johnson SB distribution is the best suited of the distributions considered for similar cases to model the variability in the compressive strength of fly ash bricks. In addition, the microstructures of these bricks were examined to investigate the cause of such variations.
1 April 2020 in Journal of Materials in Civil Engineering
Design of structures made using silica fume (SF) concrete to an acceptable level of safety requires the probabilistic evaluation of its mechanical properties. An extensive experimental program was carried out on compressive strength, flexural strength, and tensile splitting strength of SF concrete. Seven concrete mixes with different proportions of SF were designed to produce 490 concrete samples. The probabilistic models to describe the variability of the mechanical properties of SF concrete were proposed. Two-parameter probability models such as Weibull, normal, lognormal, and gamma distribution were considered for the representation of variability. The probability distribution models were selected based on goodness-of-fit tests such as the Kolmogorov-Sminrov (KS), chi-square (CS), and log-likelihood (LK) tests. The results obtained from the models are useful for description of the variability of selected mechanical properties of SF-incorporated concrete. This study proposes the lognormal distribution function as the distribution model that most closely describes the variations of different mechanical properties of SF concrete from a practical point of view. Further, the performance of typically selected buildings using SF concrete was evaluated through fragility curves and reliability indices incorporating the proposed probability distributions and variability of compressive strength property. It was found that 15%–25% of partial replacement of cement with SF may yield better performance of the frames.
1 August 2020 in Practice Periodical on Structural Design and Construction
Sustainable concrete construction has encouraged the utilization of industrial wastes [fly ash (FA), silica fume, ground granulated blast furnace slag, metakaolin, and so forth] as a composite cementitious material due to its high pozzolanic activity. Among them, fly-ash concrete is gaining high popularity in the construction industry due to its many benefits to concrete structures, including increased structural performance. To estimate the seismic performance of FA concrete buildings, a probabilistic study was performed to determine its mechanical parameters at various performance limit states. Weibull, normal, log-normal, and gamma distribution probability distribution models were considered for three goodness-of-fit tests: the Kolmogorov–Smirnov (KS), chi-square (CS), and log-likelihood (LK) tests. Among them, the lognormal distribution was found to be the closest distribution describing the variations in the mechanical properties of FA concrete compared with other distributions. It was observed that 20%–40% partial replacement of FA with cement improves the performance of structures with enhanced structural safety at economical cost.