Anna Malmros

Anna Malmros

Auto-generated profile, based on publicly available information

Anna Malmros

Gotmic AB, Gothenburg, Sweden

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 April 2020 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
DCDing-Yuan Chen
Ding-Yuan Chen
AMAnna Malmros
Anna Malmros
MTMattias Thorsell
Mattias Thorsell
HHHans Hjelmgren
Hans Hjelmgren
OKOlof Kordina
Olof Kordina
NRNiklas Rorsman
Niklas Rorsman
High performance microwave GaN-on-SiC HEMTs are demonstrated on a heterostructure without a conventional thick doped buffer. The HEMT is fabricated on a high-quality 0.25 μm unintentional doped GaN layer grown directly on a transmorphic epitaxially grown AlN nucleation layer. This approach allows the AlN-nucleation layer to act as a back-barrier, limiting short channel effects and removing buffer leakage. The devices with the ‘buffer-free’ heterostructure show competitive DC and RF characteristics, as benchmarked against the devices made on a commercial Fe-doped epi-wafer. Peak transconductances of 500 mS/mm and a maximum saturated drain current of ~1 A/mm are obtained. An extrinsic fT of 70 GHz and fmax of 130 GHz are achieved for transistors with a gate length of 100 nm. Pulsed-IV measurements reveal a lower current slump and a smaller knee walkout. The dynamic IV performance translates to an output power of 4.1 W/mm, as measured with active load-pull at 3 GHz. These devices suggest that the ‘bufferfree’ concept may offer an alternative route for high frequency GaN HEMTs with less electron trapping effects.

5 December 2018 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
AMAnna Malmros
Anna Malmros
PGPiero Gamarra
Piero Gamarra
MTMattias Thorsell
Mattias Thorsell
HHHans Hjelmgren
Hans Hjelmgren
CLCedric Lacam
Cedric Lacam
NRNiklas Rorsman
Niklas Rorsman
The impact of varying the GaN channel layer thickness (t ch ) in InAlGaN/AlN/GaN HEMTs with C-doped AlGaN back barriers is investigated. t ch was 50, 100, and 150 nm, and the gate length of the fabricated HEMTs ranged from 50 to 200 nm. It is found that short-channel effects (SCEs) are significantly mitigated with a small t ch . For HEMTs with a gate length of 50 nm, the drain-induced barrier lowering changes from 40 to 93 mV/V as t ch is increased from 50 to 150 nm. On the other hand, it is shown that dispersive effects are more severe for a smaller t ch , as demonstrated by a sixfold increase in the dynamic ON-resistance for t ch = 50 nm compared to t ch = 150 nm. The tradeoff between dispersion and SCEs is reflected in large-signal measurements at 30 GHz. The 50-nm channel, mainly limited by dispersion, exhibits an output power of 3.5 W/mm. The thicker channels reach a maximum of around 5 W/mm, but for different gate lengths due to the difference in severity of the SCEs. This paper elucidates the interplay between SCEs and dispersion related to t ch , its consequences for the large-signal performance and for the limitation in downscaling of the gate length.

22 January 2015 in IEEE Electron Device Letters
Verified
Journal Article
Closed access
AMAnna Malmros
Anna Malmros
PGPiero Gamarra
Piero Gamarra
MFMarie-Antoinette Di Forte-Poisson
Marie-Antoinette Di Forte-Poisson
HHHans Hjelmgren
Hans Hjelmgren
CLCedric Lacam
Cedric Lacam
NRNiklas Rorsman
Niklas Rorsman
Al 2 O 3 films deposited by thermal and plasma-assisted atomic layer deposition (ALD) were evaluated as passivation layers for InAlN/AlN/GaN HEMTs. As a reference, a comparison was made with the more conventional plasma enhanced chemical vapor deposition deposited SiN x passivation. The difference in sheet charge density, threshold voltage, f T and f max was moderate for the three samples. The gate leakage current differed by several orders of magnitude, in favor of Al 2 O 3 passivation, regardless of the deposition method. Severe current slump was measured for the HEMT passivated by thermal ALD, whereas near-dispersion free operation was observed for the HEMT passivated by plasma-assisted ALD. This had a direct impact on the microwave output power. Large-signal measurements at 3 GHz revealed that HEMTs with Al 2 O 3 passivation exhibited 77% higher output power using plasma-assisted ALD compared with thermal ALD.

22 January 2014 in physica status solidi (c)
Verified
Journal Article
Closed access
PDF file
AMAnna Malmros
Anna Malmros
PGPiero Gamarra
Piero Gamarra
MTMattias Thorsell
Mattias Thorsell
MFMarie‐Antoinette di Forte‐Poisson
Marie‐Antoinette di Forte‐Poisson
CLCedric Lacam
Cedric Lacam
NRNiklas Rorsman
Niklas Rorsman

5 June 2019 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
AMAnna Malmros
Anna Malmros
JCJr-Tai Chen
Jr-Tai Chen
HHHans Hjelmgren
Hans Hjelmgren
JLJun Lu
Jun Lu
LHLars Hultman
Lars Hultman
NRNiklas Rorsman
Niklas Rorsman
An enhancement of the electron mobility (μ) in InAlN/AlN/GaN heterostructures is demonstrated by the incorporation of a thin GaN interlayer (IL) between the InAlN and AlN. The introduction of a GaN IL increases μ at room temperature (RT) from 1600 to 1930 cm²/Vs. The effect is further enhanced at cryogenic temperature (5 K), where the GaN IL sample exhibits a μ of 16,000 cm²/Vs, compared to 6900 cm²/Vs without IL. The results indicate the reduction of one or more scattering mechanisms normally present in InAlN/AlN/GaN heterostructures. We propose that the improvement in μ is either due to the suppression of fluctuations in the quantum well subband energies or to reduced Coulomb scattering, both related to compositional variations in the InAlN. HEMTs fabricated on the GaN IL sample demonstrate larger improvement in dc- and high-frequency performance at 5 K; fmax increases by 25 GHz to 153 GHz, compared to an increase of 6 GHz to 133 GHz without IL. The difference in improvement was associated mainly with the drop in the access resistances.

11 November 2024 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
BHBjörn Hult
Björn Hult
JBJohan Bergsten
Johan Bergsten
RCRagnar Ferrand-Drake Del Castillo
Ragnar Ferrand-Drake Del Castillo
VDVanya Darakchieva
Vanya Darakchieva
AMAnna Malmros
Anna Malmros
NRNiklas Rorsman
Niklas Rorsman
Assessing short channel effects (SCEs) is crucial in the high-frequency optimization of downscaled field-effect transistors (FETs) such as GaN high electron mobility transistors (HEMTs). Drain-induced barrier lowering (DIBL) is commonly used for quantifying the ability of the gate to modulate the drain–source current at high drain voltages. DIBL is traditionally extracted from the relative shift of the threshold voltage at different drain–source voltages. In this article, we propose a new method based on a drain current injection technique (DCIT) to assess DIBL. This method facilitates a direct measure of the threshold voltage over a wide range of drain–source voltages in a single measurement. The method is demonstrated and compared to the conventional method using AlGaN/GaN and InAlGaN HEMTs with a Fe-doped buffer and a $\textit{C}$ -doped AlGaN back-barrier, respectively. Furthermore, the impact of different gate lengths and GaN channel layer thicknesses is presented. The measurements are analyzed and discussed with supporting technology computer-aided design (TCAD) simulations. The proposed method facilitates a more general and detailed measurement of the DIBL for HEMTs.