The hot-wall metal-organic chemical vapor deposition (MOCVD), previously shown to enable superior III-nitride material quality and high performance devices, has been explored for Mg doping of GaN. We have investigated the Mg incorporation in a wide doping range ( cm−3 up to cm−3) and demonstrate GaN:Mg with low background impurity concentrations under optimized growth conditions. Dopant and impurity levels are discussed in view of Ga supersaturation, which provides a unified concept to explain the complexity of growth conditions impact on Mg acceptor incorporation and compensation. The results are analyzed in relation to the extended defects, revealed by scanning transmission electron microscopy, x-ray diffraction, and surface morphology, and in correlation with the electrical properties obtained by Hall effect and capacitance–voltage (C–V) measurements. This allows to establish a comprehensive picture of GaN:Mg growth by hot-wall MOCVD providing guidance for growth parameters optimization depending on the targeted application. We show that substantially lower H concentration as compared to Mg acceptors can be achieved in GaN:Mg without any in situ or post-growth annealing resulting in p-type conductivity in as-grown material. State-of-the-art -GaN layers with a low resistivity and a high free-hole density (0.77 cm and cm , respectively) are obtained after post-growth annealing demonstrating the viability of hot-wall MOCVD for growth of power electronic device structures.
The performance of a novel ‘buffer-free’ AlGaN/GaN-on-SiC MISHEMTs for power switching applications is demonstrated in this letter. High voltage operation with exceptionally low gate and drain leakage currents is shown. A specific on-resistance of 3.61 m $\boldsymbol {\Omega } \cdot $ cm 2 and an abrupt breakdown voltage of 1622 V at a drain current of 22 nA/mm is achieved. Using two-terminal breakdown measurements, nitrogen-implanted GaN display breakdown fields of 0.96 MV/cm. The semi-insulating SiC substrate is capable of suppressing vertical leakage currents, ensuring that off-state operation is limited by lateral breakdown. The impact of electron trapping effects on dynamic on-resistance is small up to a drain quiescent voltage of at least 240 V. Drain current transient characteristics display a 14% increase in dynamic on-resistance with respect to quiescent drain bias, and a negligible change in resistance up to 100 ms. These types of ‘buffer-free’ heterostructures are of interest for power electronic applications above 1000 V and with potential for co-integration of power and RF-electronics.
11 November 2024 in IEEE Transactions on Electron Devices
Assessing short channel effects (SCEs) is crucial in the high-frequency optimization of downscaled field-effect transistors (FETs) such as GaN high electron mobility transistors (HEMTs). Drain-induced barrier lowering (DIBL) is commonly used for quantifying the ability of the gate to modulate the drain–source current at high drain voltages. DIBL is traditionally extracted from the relative shift of the threshold voltage at different drain–source voltages. In this article, we propose a new method based on a drain current injection technique (DCIT) to assess DIBL. This method facilitates a direct measure of the threshold voltage over a wide range of drain–source voltages in a single measurement. The method is demonstrated and compared to the conventional method using AlGaN/GaN and InAlGaN HEMTs with a Fe-doped buffer and a $\textit{C}$ -doped AlGaN back-barrier, respectively. Furthermore, the impact of different gate lengths and GaN channel layer thicknesses is presented. The measurements are analyzed and discussed with supporting technology computer-aided design (TCAD) simulations. The proposed method facilitates a more general and detailed measurement of the DIBL for HEMTs.
14 October 2025 in IEEE Transactions on Device and Materials Reliability
The high-voltage operation of GaN power high-electron mobility transistors (HEMTs) is primarily limited by electric field crowding near the gate field plates, which, over time, can degrade the dielectric properties of the passivation layer or gate insulators and compromise device reliability. Therefore, understanding the different breakdown mecha-nisms—X;their causes and locations—X;is essential for optimizing device design and improving off-state performance. Previous studies have primarily focused on device reliability in GaN HEMTs with doped buffer layers. By contrast, this study fo-cuses on the effects of prolonged off-state stress in Metal-Insu-lator-Semiconductor (MIS)-gated GaN HEMT with an Al-GaN/GaN/AlN heterostructure design without a buffer layer. The devices are investigated using electrical characteriza-tion, nanoscale structural/chemical analysis (SEM, TEM, EDS). Additionally, technology computer-aided design (TCAD) simulations are employed to describe the breakdown process by studying the electric field and charge distribution in the dielectrics. Based on the structural/chemical analysis, as well as the TCAD simulation results, it is suggested that the formation of a vertical percolation path in the SiNx passivation layer underneath the field plate edge initiates the destructive breakdown process.
Critical process modules for the fabrication of metal–insulator–semiconductor high‐electron‐mobility transistors (MISHEMTs) based on a novel ‘buffer‐free’ AlGaN/GaN heterostructure grown with metal–organic chemical vapor deposition (MOCVD) are presented. The methods of isolation and passivation for this type of heterostructure are investigated. Utilizing nitrogen implantation, it is possible to achieve off‐state destructive breakdown voltages (BVs) of 2496 V for gate–drain distances up to 25 μm, whereas mesa isolation techniques limit the BV below 1284 V. The stoichiometry of the SiNxpassivation layer displays a small impact on the static and dynamic on‐resistance. However, MISHEMTs with Si‐rich passivation show off‐state gate currents in the range of 1–100 μA mm−1at voltages above 1000 V, which is reduced below 10 nA mm−1using a stoichiometric SiNxpassivation layer. Destructive BVs of 1532 and 1742 V can be achieved using gate‐integrated and source‐connected field plates for MIHEMTs with stoichiometric and Si–rich passivation layers, respectively. By decreasing the field plate lengths, it is possible to achieve BVs of 2200 V. This demonstrates the implementation of MISHEMTs with high‐voltage operation and low leakage currents on a novel “buffer‐free” heterostructure by optimizing the SiNxstoichiometry.