Sergey V. Tsvetkov

Sergey V. Tsvetkov

Auto-generated profile, based on publicly available information

Sergey V. Tsvetkov

A.M. Prokhorov General Physics Institute of the Russian Academy of Sciences (GPI RAS), E.M. Dianov Fiber Optics Research Center, Moscow, Russia

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 October 2020 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
STSergey V. Tsvetkov
Sergey V. Tsvetkov
MKMaksim M. Khudyakov
Maksim M. Khudyakov
ALAleksey Lobanov
Aleksey Lobanov
DLDenis S. Lipatov
Denis S. Lipatov
MBMikhail M. Bubnov
Mikhail M. Bubnov
MLMikhail E. Likhachev
Mikhail E. Likhachev
A novel method of SBS gain suppression in passive single-mode optical fibers is proposed and experimentally verified. The effect is achieved due to special propagation conditions created for a number of the core-bounded acoustic modes effectively involved in the SBS, such that its gain becomes approximately evenly distributed over a wide spectral range, thereby proportionally reducing its maximum. To verify and investigate this method in depth, single-mode LMA fibers with correspondingly optimized acoustic index profiles are fabricated, experimentally tested, and analyzed. Uneven complex doping of the core with two additives, P2O5 and F, forms a high-contrast gradient acoustic index profile while maintaining a quasi-uniform optical refractive index profile. With a contrast of P2O5 of more than 6 mol.%, we achieved 8 dB of SBS suppression over conventional uniformly doped LMA fibers. Moreover, it is shown that more than 10 dB of SBS gain suppression can be achieved if the optimal dopant distribution is realized.

13 October 2023 in Photonics
Verified
Journal Article
Open access
PDF file
STSergey Tsvetkov
Sergey Tsvetkov
ALAleksey Lobanov
Aleksey Lobanov
DLDenis S. Lipatov
Denis S. Lipatov
MKMaksim M. Khudyakov
Maksim M. Khudyakov
TZTatiana Zaushitsyna
Tatiana Zaushitsyna
MLMikhail E. Likhachev
Mikhail E. Likhachev
A new design of a passive optical fiber waveguide with a large mode area (LMA) and strong stimulated Brillouin scattering (SBS) suppression is proposed. The fiber core consists of two parts: a central one, doped with Al2O3 and GeO2, and a peripheral one, doped with P2O5 and F. The doping profiles form a gradient-increasing profile of the acoustic refractive index, which effectively implements the acoustic multimode SBS suppression method. Measurements of the SBS gain spectrum and SBS threshold power were carried out, showing an increase in the SBS threshold of no less than 11 dB compared to a conventional uniformly doped passive LMA fiber.

18 August 2022 in IEEE Photonics Technology Letters
Verified
Journal Article
Closed access
MKMaksim M. Khudyakov
Maksim M. Khudyakov
STSergey V. Tsvetkov
Sergey V. Tsvetkov
AKAlexey Kosolapov
Alexey Kosolapov
MBMikhail M. Bubnov
Mikhail M. Bubnov
ALAleksey Lobanov
Aleksey Lobanov
MLMikhail E. Likhachev
Mikhail E. Likhachev
We propose and test a combined method of suppression of stimulated Brillouin scattering (SBS) in high numerical aperture (NA) optical fibers that makes it possible to use both the application of tensile-compressive stresses and the control of the transverse acoustic refractive index profile. In the experiment on the acoustically tailored Al2O3-GeO2-doped fiber (optically step-index, NA ~ 0.2) with a quasi-four-peak SBS gain spectrum ~0.8GHz wide, we used the offset-core technique to create a tensile-compression stress over the whole fiber length, controlled by small-diameter coiling. The stress causes each of the spectral peaks to broaden without overlap. Thus, at the optimal coiling diameter, an 11.3dB net SBS gain suppression has been obtained, where ~5dB is due to the tension. Ways to enhance SBS suppression in such fibers up to 18dB and more using the proposed technique are also discussed.

1 June 2017 in Proceedings of Higher Educational Institutions. Маchine Building
Verified
Journal Article
Open access
АБА.н. Барышев
А.н. Барышев
МБМгту Им. Н.э. Баумана
Мгту Им. Н.э. Баумана
СЦС.в. Цветков
С.в. Цветков

2 March 2026 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
STSergey V. Tsvetkov
Sergey V. Tsvetkov
TZTatiana S. Zaushitsyna
Tatiana S. Zaushitsyna
VAVitaliya A. Agakhanova
Vitaliya A. Agakhanova
LILiudmila D. Iskhakova
Liudmila D. Iskhakova
MYMikhail V. Yashkov
Mikhail V. Yashkov
MLMikhail E. Likhachev
Mikhail E. Likhachev
Mitigating the stimulated Brillouin scattering (SBS) problem in single-mode optical fibers is often based on complex doping allowing to create and spread multiple Brillouin resonances over a wide acoustic frequency range lowering an overall SBS gain maximum. Co-doping with Al2O3 is often used for it. However, it creates the “antiguiding” conditions for, at least, some of the acoustic waves electrostrictively excited in a vicinity of the fiber core. Conventional eigen-mode solvers have a fundamental restriction on guided acoustic modes and, thus, cannot allow one to calculate the SBS gain spectrum properly in a frequency region near and beyond the Brillouin frequency of pure silica. It requires the use of special approaches including an explicit account on the driving optical field. Here we provide a rigorous and, at the same time, relatively simple and fast method based on a development of the well-known infinite power-series expansion of a solution to the scalar inhomogeneous ordinary differential equation of the electrostrictively excited acoustic field, which has no requirement of specially fitting parameters and allows one to model exactly SBS gain spectra for arbitrarily doped (including different dopant species) conventional optical fibers. To complete the calculation framework, we also provide an experimental investigation of all required acousto-optical material parameters for GeO2, P2O5, Al2O3 and F dopants in MCVD-made fibers, on a base of which an Al2O3/GeO2/P2O5/F doping design of a single-mode optical fiber at 1.55 μm was proposed and experimentally verified featuring a multi-resonant BGS providing ∼11 dB of the SBS gain suppression relative to a standard single-mode germanosilicate fiber.