This paper presents the development of a compact optoelectronic device suitable for on-chip detection of fluorescent molecules. In order to obtain a highly integrated device, a long-pass multi-dielectric filter has been integrated with thin-film amorphous silicon photosensors on a single glass substrate. Filter rejects the excitation light, allowing the reduction of the distance between the source and the fluorescent site and avoiding the use of external optical component. The compatibility of the technological processes determined the materials and the temporal sequence of the device fabrication. The developed device has been designed for the fluorescence detection of ruthenium complex based molecules and tested, as a proof of concept, for the detection of double-stranded DNA down to 0.5 ng. Results demonstrate the correct operation of the integrated system in both rejecting the excitation light and in detecting the fluorescent signal, demonstrating the suitability of this optoelectronic platform in practical biomedical applications.
In this paper we present a system able to perform thermal treatments on lab-on-chip devices fabricated on glass substrates. The system includes a thin film resistor acting as heater and thin film hydrogenated amorphous silicon diodes acting as temperature sensors. An electronic system controls the lab-on-chip temperature through a Proportional-IntegralDerivative algorithm. In particular, an electronic board infers the system temperature measuring the voltage across the amorphous silicon diodes and drives the heater to achieve the set-point temperature. Taking into account the 16-bit ADC resolution and the sensors sensitivity, which is around 3.6 mV/ o C, we estimate that our system is able to detect temperature variation as low as 3.5·10 -3o C. Furthermore, the experimental results show that the system is able to stabilize the system temperature with a precision better than 0.1 o C.
This paper presents the design, fabrication and characterization of a thin film heater functional for thermal treatments in lab-on-chip system. The spatial temperature distribution determined by different heater geometries has been studied through electro-thermal simulations by using COMSOL Multiphysics. The heater showing the more uniform temperature distribution has been subsequently fabricated and characterized. A very good agreement between modeled and measured data has been attained. Results show a spatial temperature distribution of about ±1°C over an area comparable to the heater area and a directly USB powered heater, demonstrating the suitability of the proposed device for lab-on-chip thermal applications.
This work presents the development and testing of an integrated system for on-chip detection of thermochemiluminescent biomolecules. The activation energy of the reaction is provided by a transparent structure of thin film heaters deposited on one side of a glass substrate. Light, passing through the substrate, reaches an array of amorphous silicon differential structure deposited on the opposite side of the glass substrate. The structure is designed to perform differential current measurements between a light- shielded diode, whose current is sensitive only to temperature, and a photosensor, sensitive to both incident light and temperature. The device therefore balances the thermal variations of the photodiode current and reduces the dark-current noise. These features make the presented system very appealing as highly miniaturized micro-analytical devices for biosensing applications
9 September 2017 in Lecture Notes in Electrical Engineering