The technological process of the production of silicon nanoparticles from silicon monoxide and methods of the deposition of nanosilicon coatings onto solar cells are developed. The process makes it possible to control the particle dimensions in the range from 2 to 10 nm. The effect of such nanosilicon coatings on the efficiency of solar cells is studied. It is shown that nanosilicon films possess good antireflection and passivation properties and can be successfully used in the technology of the production of solar cells.
7 August 2014 in Physical Chemistry Chemical Physics
The arrays of metallic nanowires are considered as promising precursors for 1D semiconductor nanostructures after appropriate treatment at temperatures close to the melting point. Therefore the melting behaviour of the metallic structures in oxide templates is a key parameter for the subsequent conversion process. The present paper focuses on understanding of the effect of mechanical stress generated during heating on the melting point of the metal nanowires deposited into the pores of anodic alumina. Extremely high local compressive stress appears due to the difference in the thermal coefficients of the oxide template and nanowires inside the pores. The effect of the composite structural parameter that may be related to the concentration of nanowires on the melting temperature has been investigated. A numerical model predicting the melting point has been developed for composites with indium, tin, and zinc nanowires. The simulation results obtained using the suggested model were compared with the experimental data.
New methods for the synthesis of silicon monoxide are considered. The structure and phase composition of the compounds synthesized are studied by mass spectrometry, X-ray diffraction analysis, and IR...
The evolution of the surface morphology of LPCVD poly-Si films (deposition temperature 620°C), a-Si films (deposition temperature 550°C) and poly-Si films, obtained by the crystallization of a-Si is investigated in the thickness range 40–500 nm. It is found that upon an increase in the thickness from 40 to 500 nm, the surface roughness (parameters Sq, Sz, Sv) is increased for poly-Si, while in the case of a-Si and poly-Si obtained by crystallization a-Si, on the contrary, decreases. The correlation length (Sal) increases for all three types of silicon films. Poly-Si films, obtained by the crystallization of a-Si, as compared to LPCVD poly-Si films have a significantly lower surface roughness, respectively, Sq two times less at a thickness of 40 nm and sixteen times less at 500 nm. In contrast to thick films, thin a-Si films (at thicknesses of less than 40 nm) have a granular structure, which is especially pronounced at an average thickness of about 20 nm and there is a maximum on the dependence of the roughness Sq on the thickness.