Functional oxides are considered as promising materials for photonic applications due to their extraordinary and various optical properties. Especially, yttria-stabilized zirconia (YSZ) has a high refractive index (∼2.15), leading to a good confinement of the optical mode in waveguides. Furthermore, YSZ can also be used as a buffer layer to expand toward a large family of oxides-based thin-films heterostructures. In this paper, we report a complete study of the structural properties of YSZ for the development of integrated optical devices on sapphire in telecom wavelength range. The substrate preparation and the epitaxial growth using pulsed-laser deposition technique have been studied and optimized. High-quality YSZ thin films with remarkably sharp x-ray diffraction rocking curve peaks in range have then been grown on sapphire (0001). It was demonstrated that a thermal annealing of sapphire substrate before the YSZ growth allowed controlling the out-of-plane orientation of the YSZ thin film. Single-mode waveguides were finally designed, fabricated, and characterized for two different main orientations of high-quality YSZ (001) and (111). Propagation loss as low as 2 dB/cm at a wavelength of 1380 nm has been demonstrated for both orientations. These results pave the way for the development of a functional oxides-based photonics platform for numerous applications including on-chip optical communications and sensing.
Vanadium dioxide exhibits a metal to insulator transition close to room temperature, making it very interesting in particular for radio frequency (RF) device applications. Here, we compare the structural and RF properties of VO2 thin films grown by magnetron sputtering on c-cut and r-cut sapphire substrates. The epitaxial growth of VO2 on c-cut sapphire gives rise to several crystallographic variants for the insulating M1 phase. Moreover, during the structural transition, simultaneous presence of both metallic and insulating phases is evidenced by x-ray diffraction over a large temperature range. Films grown on r-cut sapphire exhibit only two variants and present a very narrow temperature range of their structural transition. Interestingly, such structural differences of the films grown on c- and r-cut sapphire substrates have very little influence on their dc resistivity, while the transmission of the RF signal through the metallic phase was found much lower on c-cut than on r-cut sapphire. This supports the fact that r-cut sapphire is preferable for VO2-based RF device fabrication.