Ultra-wide bandgap (UWBG) Al0.65Ga0.35N channel high electron mobility transistors (HEMTs) were deposited using a close-coupled showerhead metal-organic chemical vapor deposition reactor on AlN-on-sapphire templates to investigate the effect of transport properties of the two-dimensional electron gas (2DEG) on the epitaxial structure design. The impact of various scattering phenomena on AlGaN channel HEMTs was analyzed with respect to the channel, buffer, and AlN interlayer design, revealing that the alloy disorder and ionized impurity scattering mechanisms were predominant, limiting the mobility of 2DEG up to 180 cm2/Vs for a sheet charge density of 1.1 × 1013 cm−2. A surface roughness of <1 nm (2 μm × 2 μm atomic force microscopy scan) was achieved for the epitaxial structures demonstrating superior crystalline quality. The fabricated HEMT device showed state-of-the-art contact resistivity (ρc = 8.35 × 10−6 Ω · cm2), low leakage current (105), a breakdown voltage of 2.55 kV, and a Baliga's figure of merit of 260 MW/cm2. This study demonstrates the optimization of the structural design of UWBG AlGaN channel HEMTs and its effect on transport properties to obtain state-of-the-art device performance.
Al-rich AlGaN has emerged as a promising material for high-voltage power electronics due to its exceptional critical electric field (>10 MV/cm). In this work, we demonstrate passivated and field-plated high voltage Al0.65Ga0.35N channel transistors. For >2.7 kV breakdown voltage, a high Baliga figure of merit (BFOM) of close to 400 MW/cm2 using gate pad connected and source pad connected field plates were obtained for Al0.65Ga0.35N channel HEMTs. Additionally, we also report a non-passivated Al0.65Ga0.35N channel HEMTs with >3 kV breakdown voltage and a high BFOM of 569 MW/cm². Furthermore, a low contact resistance of ~2.6 Ω·mm for >60% AlGaN channel FETs on bulk AlN substrates was also obtained. These results provide advances which will help establish AlGaN channel transistors as a compelling candidate for next-generation high-voltage power electronics.
1 March 2024 in Japanese Journal of Applied Physics
Ultra-small (10 μm) InGaN-based red microLEDs (625 nm at 1 A cm−2) are necessary for modern displays. However, an increase in surface-area-to-volume ratio with a decrease in the micro-LED size resulting in higher surface recombination causes a drop in efficiency with device size. In this letter, we demonstrate microLEDs from 60 μm down to 3 μm with significantly reduced sidewall-related efficiency reduction using a two-step passivation technique using Al2O3 and Si3N4. The peak on-wafer EQE changes from 0.21% to 0.35% as the device size reduces from 60 to 3 μm, possibly due to improved light extraction efficiency for smaller mesa-widths.
In this letter, a MOCVD-grown Al0.66Ga0.34N channel Metal-Insulator-Semiconductor-High-Electron-Mobility-Transistor (MISHEMT) with a scaled T-gate structure was fabricated on a single-crystal bulk AlN substrate. A device with 4 μm source-to-drain spacing achieved a record-high Johnson’s figure of merit (JFOM) of 20.92 THz·V, enabled by the high-Al channel, high-quality substrate and gate field-plate. The corresponding cutoff and maximum oscillation frequencies are 22.5 GHz and 46 GHz, respectively, with a breakdown voltage of 930 V. A current collapse of 15% was observed under 30 V drain bias, indicating excellent RF performance and the potential of bulk-AlN-based AlGaN channel HEMTs for advanced RF applications
In this article, a high-composition (>35%) thick-barrier (>30 nm) AlGaN/AlN/GaN high-electron-mobility transistor (HEMT) structure grown on a sapphire substrate with ultra-low sheet resistivity (<250 Ω/□) is reported. The optimization of growth conditions, such as reduced deposition rate, and the thickness optimization of different epitaxial layers allowed us to deposit a crack-free high-composition and thick AlGaN barrier layer HEMT structure. A significantly high two-dimensional electron gas (2DEG) density of 1.46 × 1013 cm−2 with a room-temperature mobility of 1710 cm2/V·s was obtained via Hall measurement using the Van der Pauw method. These state-of-the-art results show great potential for high-power Ga-polar HEMT design on sapphire substrates.
Thin Si-doped Al-rich (xAl > 0.85) regrown Al(Ga)N layers were deposited on AlN on sapphire template using metal-organic chemical vapor deposition (MOCVD) techniques. The optimization of the deposition conditions, such as temperature (1150 °C), V/III ratio (750), deposition rate (0.7 Å/s), and Si concentration (6 × 1019/cm3), resulted in a high charge carrier concentration (> 1015 cm−3) in the Si-doped Al-rich Al(Ga)N films. A pulsed deposition condition with pulsed triethylgallium and a continuous flow of trimethylaluminum and ammonia was employed to achieve a controllable Al composition xAl > 0.95 and to prevent unintended Ga incorporation in the AlGaN material deposited using the close-coupled showerhead reactor. Also, the effect of unintentional Si incorporation on free charge carrier concentration at the regrowth interface was studied by varying the thickness of the regrown Al(Ga)N layer from 65 to <300 nm. A maximum charge carrier concentration of 4.8 × 1016 and 7.5 × 1015/cm3 was achieved for Al0.97Ga0.03N and AlN films with thickness <300 nm compared to previously reported n-Al(Ga)N films with thickness ≥400 nm deposited using MOCVD technique.