26 March 2018 in Journal of Physics D: Applied Physics
8 June 2012 in IEEE Electron Device Letters
BSBerardi Sensale-Rodriguez
Berardi Sensale-Rodriguez
+10
We report 30-nm-gate-length InAlN/AlN/GaN/SiC high-electron-mobility transistors (HEMTs) with a record current gain cutoff frequency (fT) of 370 GHz. The HEMT without back barrier exhibits an extrinsic transconductance (gm.ext) of 650 mS/mm and an on/off current ratio of 106 owing to the incorporation of dielectric-free passivation and regrown ohmic contacts with a contact resistance of 0.16 Ω·mm. Delay analysis suggests that the high fT is a result of low gate-drain parasitics associated with the rectangular gate. Although it appears possible to reach 500-GHz fT by further reducing the gate length, it is imperative to investigate alternative structures that offer higher mobility/velocity while keeping the best possible electrostatic control in ultrascaled geometry.
19 September 2011 in IEEE Electron Device Letters
This letter reports lattice-matched In0.17Al0.83N/GaN high-electron-mobility transistors on a SiC substrate with a record current gain cutoff frequency (fT) of 300 GHz. To suppress the short-channel effects (SCEs), an In0.15Ga0.85N back barrier is applied in an InAlN/GaN heterostructure for the first time. The GaN channel thickness is also scaled to 26 nm, which allows a good immunity to SCEs for gate lengths down to 70 nm even with a relatively thick top barrier (9.4-10.4 nm). In a 30-nm-gate-length device with an on-resistance (Ron) of 1.2 Ω · mm and an extrinsic transconductance (gm.ext) of 530 mS/mm, a peak fa of 300 GHz is achieved. An electron velocity of 1.37-1.45 × 107 cm/s is extracted by two different delay analysis methods.
9 July 2008 in IEEE Electron Device Letters
High-electron mobility transistors (HEMTs) based on ultrathin AIN/GaN heterostructures with a 3.5-nm AlN barrier and a 3-nm Al2O3 gate dielectric have been investigated. Owing to the optimized AIN/GaN interface, very high carrier mobility (~1400 cm2/V ldr s) and high 2-D electron-gas density (~2.7times1013/cm2) resulted in a record low sheet resistance (~165 Omega/sq). The resultant HEMTs showed a maximum dc output current density of ~2.3 A/mm and a peak extrinsic transconductance gm,ext~480 mS/mm (corresponding to gm,int~1 S/mm). An fT/fmax of 52/60 GHz was measured on 0.25times60 mum2 gate HEMTs. With further improvements of the ohmic contacts, the gate dielectric, and the lowering of the buffer leakage, the presented results suggest that, by using AIN/GaN heterojunctions, it may be possible to push the performance of nitride HEMTs to current, power, and speed levels that are currently unachievable in AlGaN/GaN technology.
7 October 2010 in IEEE Electron Device Letters
Having a drain current density of 1.9 A/mm, a peak extrinsic transconductance of 800 mS/mm (the highest reported in III-nitride transistors), ft/fmax of 70/105 GHz, and Vbr of 29 V, 150-nm-gate enhancement-mode InAlN/AlN/GaN high-electron-mobility transistors are demonstrated on SiC substrates using plasma-based gate-recess etch. The possible plasma-induced damage in the gate region was investigated using interface-trap states extracted from temperature-dependent subthreshold slopes.
29 April 2011 in IEEE Electron Device Letters
We report lattice-matched In 0.17 Al 0.83 N/GaN high-electron mobility transistors on a SiC substrate with a record current gain cutoff frequency ( fT ). The key to this performance is the use of an oxygen plasma treatment to form a thin oxide layer on the InAlN barrier and to reduce the gate leakage current by more than two orders of magnitude. In addition, the RF transconductance ( g m ) collapse is reduced in the O 2 -treated devices, which results in a significant improvement in the f T . In a transistor with a gate length of 30 nm, an f T of 245 GHz is achieved, the highest value ever reported in GaN-based field-effect transistors.