1 May 2019 in IEEE Electron Device Letters
ecoverable residual image characteristics for n-and p-type low-temperature polycrystalline silicon (LTPS) thin-film transistor (TFT)-based organic light-emitting diode (OLED) displays using polyimide substrates were investigated. Unlike OLED displays using glass substrates, the n-type LTPS TFT-based OLED displays using a polyimide substrate showed inferior recoverable residual image characteristics compared to p-type LTPS TFT-based OLED displays. By analysis of the brightness relaxation characteristics of the residual image and technology computer-aided design (TCAD) simulations, an additional explanation for the recoverable residual image, related to the substrate, was identified. In the polyimide substrate, internal electric fields vary depending on the operation of the driving TFTs. Particularly in n-type LTPS driving TFTs, the direction of electric fields changes dramatically with brightness conditions. This can result in a drastic variation in charge behavior inside the polyimide substrate. Consequently, we found that, when using a polyimide substrate rather than a glass substrate, the recoverable residual image characteristics of OLED displays arise due to both the hysteresis characteristics of LTPS TFTs and the charge generation and distribution in the polyimide substrate.
14 July 2022 in IEEE Transactions on Electron Devices
This article proposes a new driving scheme based on an n-type low-temperature polycrystalline silicon (LTPS) four-transistor-two-capacitor (4T2C) pixel circuit to improve the quality of motion images of active matrix organic light-emitting diode (AMOLED) displays. The proposed driving scheme can prevent the effect of the lateral leakage current flowing through the OLED common layer by keeping the pixels in the upper and lower row lines in a nonemitting hold period during the program period. The simulation results show that all RGB colors maintain a shooting amount ratio (SAR) below 1% from the first frame when the image is switched from black to white, even for a concentration of the high p-doped hole transport layer (p-HTL). In addition, the parasitic capacitances of the 4T2C pixel circuit that causes OLED current errors are thoroughly analyzed for high luminance uniformity. A 1.5-in 326 pixels per inch (PPI) AMOLED panel based on the proposed driving scheme was fabricated. The results of our measurements show that the SARs of RGB colors are 0.8%, 0.2%, and 0.9%, respectively, and the average $\textit{x}$ -coordinate shift of the color is 0.007 during the transition between black and white images due to the effective suppression of the lateral leakage current. Therefore, we demonstrate that the proposed driving scheme is suitable for AMOLED displays that require high-quality motion images.
29 July 2024 in IEEE Access
This paper proposes a new method that adjusts anode-initialization voltage of light-emitting diodes (OLEDs) depending on temperature to mitigate temperature-sensitive low-luminance inconsistency. Active-matrix OLED displays are increasingly adopting higher refresh rates (HRRs) to ensure fast and smooth image transitions. Experimental studies indicate that ultra-low-luminance-levels (ULLLs) with very low driving currents become more sensitive with rapid anode voltage initialization cycle after applying HRRs. This sensitivity stems from the anode charging slope, intertwined with OLED characteristics. It is important to note that OLED turn-on voltage and current density depend on temperature. To address this, we analyzed the influences of driving currents, refresh rates, and temperature on ULLL expressions. Subsequently, we propose an adjustable anode initialization voltage depending on temperature. The proposed method successfully reduced luminance changes from ~100% to less than 1% over the operating temperature range from 0°C to 50°C.