superconductor has a great potential for applications because of its high and , exceeding those of any Nb-base superconductors at any temperature. It is now important to understand its flux pinning so as to raise to high values over a wide field range. We show that nanometer-sized columnar-grain structure can produce exceeding . The angular dependence of indicates that the strongest pinning occurs when the field is aligned parallel to the grain boundaries. Our results confirm earlier deductions that grain boundaries in act as effective pinning centers like those in .
Pinning centers were successfully introduced into the (1223) phase of Tl–Sr–Ca–Cu–O system using its derivative (Tl/Pb)–(Sr/Ba)–Ca–Cu–O with the nominal composition of (0.5/0.5)−(1.6/0.4)–2–3. The bulk sample showed a strong flux pinning characteristics. The critical current density, Jc, was obtained from the magnetization measurement. The intragrain Jc was ∼43,000 A/cm2 at 77 K and 1 T. The transport Jc of a tape with the (1223) material in core was ∼500 A/cm2 at 77 K and 5 T.
1 November 1991 in Physica C: Superconductivity and its Applications
Single phase TlSr2CaCu2O7 was synthesized, and the crystal structure was refined from X-ray powder diffraction data using Rietveld analysis. The structure has single Tl-O sheets and tetragonal symmetry (a=3.7859 Å, c=12.104 Å) with space group P4/mmm, and is similar to TlBa2CaCu2O7 and Tl0.5Pb0.5Sr2CaCu2O7 (1212 type). Possible substitution of about 14% of Ca-sites with Tl ions was suggested.
This paper reports the possibility of High Temperature Superconductor (HTS) magnetic flux pump for the compensation of slight current decay in persistent mode HTS magnet. As a first step, the linear type magnetic flux pump (LTMFP) is fabricated with the use of the wound BSCCO tapes, and then the preliminary pumping test is carried out by using NbTi load coil in liquid helium. Further, the current transport property of the produced MgB2 thin films is measured, and then the fabrication of the LTMFP has been completed for the purpose of the higher performance as well as higher temperature (e.g., 20 K) operation.