1 December 1998 in Physica C: Superconductivity and its Applications
15 September 2014 in Applied Physics Letters
Superconducting flux pumps enable large currents to be injected into a superconducting circuit, without the requirement for thermally conducting current leads which bridge between the cryogenic environment and room temperature. In this work, we have built and studied a mechanically rotating flux pump which employs a coated conductor high-Tc superconducting (HTS) stator. This flux pump has been used to excite an HTS double pancake coil at 77 K. Operation of the flux pump causes the current within the superconducting circuit to increase over time, before saturating at a limiting value. Interestingly, the superconducting flux pump is found to possess an effective internal resistance, Reff, which varies linearly with frequency, and is two orders of magnitude larger than the measured series resistance of the soldered contacts within the circuit. This internal resistance sets a limit for the maximum achievable output current from the flux pump, which is independent of the operating frequency. We attribute this effect to dynamic resistance within the superconducting stator wire which is caused by the interaction between the DC transport current and the imposed alternating magnetic field. We provide an analytical expression describing the output characteristics of our rotating flux pump in the high frequency limit, and demonstrate that it describes the time-dependent behavior of our experimental circuit. Dynamic resistance is highlighted as a generic issue that must be considered when optimizing the design of an HTS flux pump.
3 November 2004 in Superconductor Science and Technology
20 June 2008 in Superconductor Science and Technology
17 January 2017 in Superconductor Science and Technology
Superconducting high- T c coated conductor (CC) wires comprise a ceramic thin film with a large aspect ratio. This geometry can lead to significant dissipative losses when exposed to an alternating magnetic field. Here we report experimental measurements of the ‘dynamic resistance’ of commercially available SuperPower and Fujikura CC wires in an AC perpendicular field. The onset of dynamic resistance occurs at a threshold field amplitude, which is determined by the total DC transport current and the penetration field of the conductor. We show that the field-dependence of the normalised magnetisation loss provides an unambiguous value for this threshold field at zero transport current. From this insight we then obtain an expression for the dynamic resistance in perpendicular field. This approach implies a linear relationship between dynamic resistance and applied field amplitude, and also between threshold field and transport current and this is consistent with our experimental data. The analytical expression obtained yields values that closely agree with measurements obtained across a wide range of frequencies and transport currents, and for multiple CC wires produced by different wire manufacturers and with significantly differing dimensions and critical currents. We further show that at high transport currents, the measured DC resistance includes an additional nonlinear term which is due to flux-flow resistance incurred by the DC transport current. This occurs once the field-dependent critical current of the wire falls below the DC transport current for part of each field cycle. Our results provide an effective and simple approach to calculating the dynamic resistance of a CC wire, at current and field magnitudes consistent with those expected in superconducting machines.
6 June 2018 in Superconductor Science and Technology