We applied a new method to compute tsunami Green's functions for slip inversion of the 1 April 2014 Iquique earthquake using both near‐field and far‐field tsunami waveforms. Inclusion of the effects of the elastic loading of seafloor, compressibility of seawater, and the geopotential variation in the computed Green's functions reproduced the tsunami traveltime delay relative to long‐wave simulation and allowed us to use far‐field records in tsunami waveform inversion. Multiple time window inversion was applied to tsunami waveforms iteratively until the result resembles the stable moment rate function from teleseismic inversion. We also used GPS data for a joint inversion of tsunami waveforms and coseismic crustal deformation. The major slip region with a size of 100 km × 40 km is located downdip the epicenter at depth ~28 km, regardless of assumed rupture velocities. The total seismic moment estimated from the slip distribution is 1.24 × 1021 N m (Mw 8.0).
We proposed a source model for the 16 September 2015 Illapel (Chile) tsunamigenic earthquake using teleseismic and tsunami data. The 2015 epicenter was at the northernmost of the aftershocks zone of the 2010 Mw 8.8 Maule earthquake. Teleseismic body wave inversions and tsunami simulations showed optimum rupture velocities of 1.5–2.0 km/s. The agreement between observed and synthetic waveforms was quantified using normalized root‐mean‐square (NRMS) misfit. The variations of NRMS misfits were larger for tsunami data compared to the teleseismic data, because tsunami waveforms are more sensitive to the spatial distribution of slip. The large‐slip area was 80 km (along strike) × 100 km (along dip) with an average slip of 5.0 m and depth of 12–33 km, located ~70 km to the northwest of the epicenter. We obtained a seismic moment of 4.42 × 1021 Nm equivalent to Mw 8.4. Results may indicate a northward stress transfer from the 2010 Maule earthquake.
1 August 2012 in Earth and Planetary Science Letters
The 2010 Mentawai earthquake (magnitude 7.7) generated a destructive tsunami that caused more than 500 casualties in the Mentawai Islands, west of Sumatra, Indonesia. Seismological analyses indicate that this earthquake was an unusual “tsunami earthquake,” which produces much larger tsunamis than expected from the seismic magnitude. We carried out a field survey to measure tsunami heights and inundation distances, an inversion of tsunami waveforms to estimate the slip distribution on the fault, and inundation modeling to compare the measured and simulated tsunami heights. The measured tsunami heights at eight locations on the west coasts of North and South Pagai Island ranged from 2.5 to 9.3 m, but were mostly in the 4–7 m range. At three villages, the tsunami inundation extended more than 300 m. Interviews of local residents indicated that the earthquake ground shaking was less intense than during previous large earthquakes and did not cause any damage. Inversion of tsunami waveforms recorded at nine coastal tide gauges, a nearby GPS buoy, and a DART station indicated a large slip (maximum 6.1 m) on a shallower part of the fault near the trench axis, a distribution similar to other tsunami earthquakes. The total seismic moment estimated from tsunami waveform inversion was 1.0 × 1021 Nm, which corresponded to Mw 7.9. Computed coastal tsunami heights from this tsunami source model using linear equations are similar to the measured tsunami heights. The inundation heights computed by using detailed bathymetry and topography data and nonlinear equations including inundation were smaller than the measured ones. This may have been partly due to the limited resolution and accuracy of publically available bathymetry and topography data. One-dimensional run-up computations using our surveyed topography profiles showed that the computed heights were roughly similar to the measured ones.