Antonino Fabio Pisciotta

Antonino Fabio Pisciotta

Auto-generated profile, based on publicly available information

Antonino Fabio Pisciotta

Istituto Nazionale di Geofisica e Vulcanologia (INGV), Palermo, Italy

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 November 2021 in Natural Hazards and Earth System Sciences
Verified
Journal Article
Open access
PDF file
AGALESSANDRO GATTUSO
ALESSANDRO GATTUSO
Francesco ItalianoFrancesco Italiano
Francesco Italiano
GCGiorgio Capasso
Giorgio Capasso
ADAntonino D'Alessandro
Antonino D'Alessandro
Fausto GrassaFausto Grassa
Fausto Grassa
DRDavide Romano
Davide Romano
The Santa Barbara and Aragona areas are affected by mud volcanism (MV) phenomena, consisting of continuous or intermittent emission of mud, water, and gases. This activity could be interrupted by paroxysmal events, with an eruptive column composed mainly of clay material, water, and gases. They are the most hazardous phenomena, and today it is impossible to define the potential parameters for modelling the phenomenon. In 2017, two digital surface models (DSMs) were performed by drone in both areas, thus allowing the mapping of the emission zones and the covered areas by the previous events. Detailed information about past paroxysms was obtained from historical sources, and, with the analysis of the 2017 DSMs, a preliminary hazard assessment was carried out for the first time at two sites. Two potentially hazardous paroxysm surfaces of 0.12 and 0.20 km2 for Santa Barbara and Aragona respectively were defined. In May 2020, at Aragona, a new paroxysm covered a surface of 8721 m2. After this, a new detailed DSM was collected with the aim to make a comparison with the 2017 one. Since 2017, a seismic station was installed in Santa Barbara. From preliminary results, both seismic events and ambient noise showed a frequency of 5–10 Hz.

11 December 2020 in Archaeological Prospection
Verified
Journal Article
Closed access
PDF file
Antonio CostanzoAntonio Costanzo
Antonio Costanzo
APAntonino Pisciotta
Antonino Pisciotta
MAMaria Ilaria Pannaccione Apa
Maria Ilaria Pannaccione Apa
SBSimona Bongiovanni
Simona Bongiovanni
Patrizia CapizziPatrizia Capizzi
Patrizia Capizzi
Raffaele MartoranaRaffaele Martorana
Raffaele Martorana

18 September 2024 in Solid Earth
Verified
Journal Article
Open access
PDF file
DMDaniel Müller
Daniel Müller
Thomas WalterThomas Walter
Thomas Walter
VTValentin R. Troll
Valentin R. Troll
JSJessica Stammeier
Jessica Stammeier
AKAndreas Karlsson
Andreas Karlsson
BJBenjamin De Jarnatt
Benjamin De Jarnatt
Hydrothermal alteration and mineralization processes can affect the physical and chemical properties of volcanic rocks. Aggressive acidic degassing and fluid flow often also lead to changes in the appearance of a rock, such as changes in surface coloration or intense bleaching. Although hydrothermal alteration can have far-reaching consequences for rock stability and permeability, limited knowledge exists on the detailed structures, extent, and dynamic changes that take place near the surface of hydrothermal venting systems. By integrating drone-based photogrammetry with mineralogical and chemical analyses of rock samples and surface gas flux, we investigate the structure of the evolving volcanic degassing and alteration system at the La Fossa cone on the island of Vulcano, Italy. Our image analysis combines principal component analysis (PCA) with image classification and thermal analysis through which we identify an area of approximately 70 000 m2 that outlines the maximum extent of hydrothermal alteration effects at the surface, represented by a shift in rock color from reddish to gray. Within this area, we identify distinct gradients of surface coloration and temperature that indicate a local variability in the degassing and alteration intensity and define several structural units within the fumarole field. At least seven such larger units of increased activity could be constrained. Through mineralogical and geochemical analysis of samples from the different alteration units, we define a relationship between surface appearance in drone imagery and the mineralogical and chemical composition. Gradients in surface color from reddish to gray correlate with a reduction in Fe2O3 from up to 3.2 % in the unaltered regime to 0.3 % in the altered regime, and the latter coincides with the area of increased diffuse acid gas flux. As the pixel brightness increases towards higher alteration gradients, we note a loss of the initial (igneous) mineral fraction and a change in the bulk chemical composition with a concomitant increase in sulfur content from close to 0 % in the unaltered samples to up to 60 % in samples from the altered domains. Using this approach of combined remote-sensing and in situ analyses, we define and spatially constrain several alteration units and compare them to the present-day thermally active surface and degassing pattern over the main crater area. The combined results permit us to present a detailed anatomy of the La Fossa fumarole field, including high-temperature fumaroles and seven larger units of increased alteration intensity, surface temperature, and variably intense surface degassing. Importantly, we also identify apparently sealed surface domains that prevent degassing, likely as a consequence of mineral precipitation from degassing and alteration processes. By assessing the thermal energy release of the identified spatial units quantitatively, we show that thermal radiation of high-temperature fumaroles accounts for < 50 % of the total thermal energy release only and that the larger part is emitted by diffuse degassing units. The integrated use of methods presented here has proven to be a useful combination for a detailed characterization of alteration and activity patterns of volcanic degassing sites and has the potential for application in alteration research and for the monitoring of volcanic degassing systems.

28 July 2023 in EGUsphere
Verified
Preprint
Open access
PDF file
DMDaniel Müller
Daniel Müller
Thomas WalterThomas Walter
Thomas Walter
VTValentin R. Troll
Valentin R. Troll
JSJessica Stammeier
Jessica Stammeier
AKAndreas Karlsson
Andreas Karlsson
BJBenjamin De Jarnatt
Benjamin De Jarnatt
Hydrothermal alteration processes can affect the physical and chemical properties of volcanic rocks and develop via complex degassing and fluid flow systems and regimes. Although alteration can have far-reaching consequences for rock stability and permeability, little is known about the detailed structures, extent, and dynamic changes that take place in hydrothermal venting systems. By combining drone-based remote sensing with mineralogical and chemical analyses of rock and gas samples, we analyzed the structure and internal anatomy of a dynamic evolving volcanic degassing and alteration system at the La Fossa cone, Vulcano Island (Italy). From drone image analysis, we revealed a ~70,000 m2 sized area subject to hydrothermal activity, for which we could determine distinct alteration gradients. By mineralogical and geochemical sampling of the zones of those alteration gradients, we study the relation between surface coloration and mineralogical and chemical composition. With increasing pixel brightness towards higher alteration gradients, we find a loss of initial mineral fraction and bulk chemical composition and a simultaneous gain in sulfur content. Using this approach, we defined and spatially constrained alteration units and compared them to the present-day thermally active surface and degassing pattern. The combined results permit us to present a detailed anatomy of the La Fossa fumarole field, highlighting 7 major units of alteration and present-day diffuse activity that, next to the high-temperature fumaroles, significantly contribute to the total activity.

13 March 2026
Verified
Conference Paper
Open access
WDWalter D’Alessandro
Walter D’Alessandro
GSGiovanni Schiera
Giovanni Schiera
APAntonino Fabio Pisciotta
Antonino Fabio Pisciotta
SBSergio Bellomo
Sergio Bellomo
Mt. Etna has long been considered one of the major sources of volcanic gases worldwide. Variations in degassing activity have been therefore considered as precious indications about the activity status of the volcanic system. Though most of the gases are released by open-conduit degassing through the summit craters, a significant part of the gases diffuses through the flanks of the volcano interacting with groundwater. Acquisition of physico-chemical parameters in groundwater for volcanic surveillance purposes started on Mt. Etna nearly 40 year ago. While in the first years only periodic sampling, generally with a monthly frequency, was made, in recent years automatic monitoring stations with higher acquisition frequency (hourly) and data transmission were implemented in several groundwater sampling sites.Moreover, the complex geodynamic situation of the eastern flank of the volcano, with tectonic and volcano-tectonic activity and flank sliding, will also have some influence on the acquired signals at the groundwater monitoring stations.In this framework, important results are expected from monitoring of the high-frequency oscillations of water level of aquifers, a powerful tool in studying stress and strain conditions in the crust. The present experiment will represent the first time that this portion of the spectrum of the water level signal will be explored in the attempt to recognize possible precursory patterns. Given the peculiarity of the area, we will focus on episodes of magma migration, volcano tectonic events and degassing, as recognized by ground deformation, seismicity and geochemical signals, which cause the propagation elastic energy in the aquifer and can thus produce high-frequency pressure signals. The presence on the area of a well-developed network for measurement of ground deformation will allow in fact to relate our hydrological signals to inflation, deflation of the edifice and sliding of its eastern flank.A prototype station for measurement of high-frequency (from 0.1 to 50 Hz) variation of pore pressure with an innovative absolute pressure sensor in 2.5mm case with 24bit resolution and 0-2 or 0-4 bar range has been implemented. The station acquires also the following parameters: water temperature, pH, electric conductivity. For the necessary tests, the station will be placed soon in an abandoned well with limited anthropogenic interference in the surrounding area on the eastern flank of Mt. Etna.

14 March 2026
Verified
Conference Paper
Open access
MGMassimiliano Guastella
Massimiliano Guastella
Raffaele MartoranaRaffaele Martorana
Raffaele Martorana
APAntonino Pisciotta
Antonino Pisciotta
ADAntonino D'ALessandro
Antonino D'ALessandro
Mud volcanoes are highly dynamic geohazard environments in which surface conditions can change over very short timescales due to episodic mud extrusion, flow, drying, cracking and oxidation. The resulting landscapes are spatially heterogeneous and typically include mixtures of fresh and weathered mud, crusted deposits, bare soil and dense or sparse vegetation. Considering the opportunities offered by deep learning for environmental monitoring, a consistent categorization of these surfaces is essential to quantify spatial patterns through time and to assess the evolution of active areas. However, progress is often limited by the lack of high quality, domain-specific labelled datasets. This gap slows the adoption of deep learning models in specialized environmental settings such as mud volcanoes, because the most readily available training datasets are largely drawn from urban and human-centered contexts. While manual annotation can partially compensate for limited training data, it is labor-intensive and difficult to standardize across operators, especially where class transitions are gradual and boundaries are diffuse rather than sharp.This study investigates how multispectral orthophotos can support separation of key mud volcano surface features and thereby accelerate mask creation for dataset generation. We present a case study at the Aragona mud volcano field (Sicily, Italy), called the Maccalube, using imagery acquired with a DJI Mavic 3 Multispectral and processed into an orthomosaic with Agisoft Metashape. We first evaluated common soil and vegetation oriented spectral indices as separability baselines. In this setting, however, baseline indices can be ambiguous because wet clay-rich substrates and thin surface water films may yield intermediate responses that overlap low cover vegetation. We additionally tested common rapid segmentation methods on the RGB orthomosaic including K-means, Simple Linear Iterative Clustering and Segmentate Anything. These algorithms show poor performance, often merging distinct classes and fragmenting individual ones, which requires substantial manual correction.We therefore introduce a practical band combination that integrates information from the visible channels with the red-edge and near-infrared bands to improve discrimination between vegetation, wet mud and drier or more weathered mud areas. The calculation is constructed in two steps: first, the visible channels are combined into a neutrality term that increases when RGB responses are similar (low color contrast). Second, this term is multiplied by an inverted red-edge contrast component derived from the near-infrared and red-edge bands, reducing the output where a strong red-edge rise is present. The result of the proposed band combination is a pre-labelling layer that can be thresholded to generate candidate masks with improved vegetation suppression. Remaining ambiguities are mainly confined to non-vegetated materials with similar dark appearance, including very fresh dark mud versus other bare substrates. Overall, the workflow offers a practical way to accelerate mask creation in domains where labelled data are limited. It supports the rapid development of domain specific training datasets for deep learning applications, in light of future automated monitoring of these environments.