The phase transition from the non-polar α-phase to the polar β-phase of poly(vinylidene fluoride) (PVDF) has been investigated using micro-Raman spectroscopy, which is advantageous because it is a nondestructive technique. Films of α-PVDF were subjected to stretching under controlled rates at 80 °C, while the transition to β-PVDF was monitored by the decrease in the Raman band at 794 cm −1 characteristic of the α-phase, along with the concomitant increase in the 839 cm −1 band characteristic of the β-phase. The α→β transition in our PVDF samples could be achieved even for the sample stretched to twice (2×-stretched) the initial length and it did not depend on the stretching rate in the range between 2.0 and 7.0 mm/min. These conclusions were corroborated by differential scanning calorimetry (DSC) and X-ray diffraction experiments for PVDF samples processed under the same conditions as in the Raman scattering measurements. Poling with negative corona discharge was found to affect the α-PVDF morphology, improving the Raman bands related to this crystalline phase. This effect is minimized for films stretched to higher ratios. Significantly, corona-induced effects could not be observed with the other experimental techniques, i.e., X-ray diffraction and infrared spectroscopy.
We report on light-emitting devices based on a green-phosphor compound (Mn-doped zinc silicate, Zn2SiO4:Mn) dispersed in a conductive polymeric blend (poly-o-methoxyaniline/polyvinylene fluoride, POMA/PVDF-TrFE). The devices exhibited high luminance in the green, good stability and homogeneous brilliance over effective areas up to 5 cm2. The electroluminescence (EL) spectrum presented essentially the same characteristics as the photoluminescence (PL) and cathodoluminescence spectra, indicating that the light emission originates from decay of the same excited species, regardless of the excitation source. Operating characteristics were analyzed with current density–voltage (J–V ) and luminance–voltage (L–V ) curves to investigate the nature of the electroluminescence of the active material, which is still not completely understood.